Arrow Keys; Power Light; Rear Panel - HP X5400 Support Manual

Windows Media Center START button
The Windows Media Center START button is a green button located on the front panel of the Media Center
Extender. Press the button to display the Media Center Start page on the Media Center Extender. No matter
what page you are viewing, you can press the button to return to the Start page.
NOTE: The Media Center START button on the front of the Media Center Extender works the same as the
Media Center Start button on the remote control.

Arrow keys

On the front panel of the Media Center Extender you will find four arrow keys (Up, Down, Left, and Right or
four related arrow buttons) that can be used for navigation in the menus. These arrow keys are identical to the
arrow keys on the remote control.
There are two additional navigation buttons, BACK and ENTER. The BACK button navigates to the previous
page on screen while the ENTER button selects buttons on screen. These buttons are identical to the BACK and
OK buttons on the remote control.

Power Light

On the front of the Media Center Extender, the power light shows the current status of the Media Center
Extender. The power light will display one of three colors (green, red, and yellow) and the light will either be
solid, flashing slowly, or flashing quickly. The table below lists the status of the lights and what they represent.
Power Light Status
Solid green
Solid green
Fast blinking green
Fast blinking yellow
Fast blinking red
Slow blinking green (on/off)
A separate red light on the front panel of the Media Center Extender displays when an infrared (IR) command
is received from the remote control. The light displays only when a command is accepted.

Rear Panel

The rear panel of the Media Center Extender includes the following ports (connections) and switches:
Port/Switch
Ethernet port
Audio ports
Universal Serial Bus
(USB) port
Video Selection
switch
Ethernet switch
Use
Connect an Ethernet cable to this port if you are using a wired (Ethernet) home network.
Red and white ports for right and left audio output cables.
Not used at this time.
Set this switch to match the type of cable you used to connect the Media Center Extender
to your TV or other video component. If you have connected the Media Center Extender
to your TV using component video cables, set this switch to Component. If you used an
S-video cable or a composite video cable, set this switch to S-video.
Under normal circumstances, this switch is not used. If you need to use a crossover cable
to connect the Media Center Extender to the HP Media Center PC or HP Digital
Entertainment Center, this switch should be in the OUT position.
Extender Status
Starting up
Normal operation
Extender software is updating
Extender is resetting
A system failure has occurred
Test mode