Selecting The Remote Control Id (Remote Id); Switching The Video Signal Type (Tv Format); Removing The Limitation On Hdmi Video Output (Mon.chk); Restoring The Default Settings (Init) - Yamaha HTR-7065 Owner's Manual

Selecting the remote control ID (REMOTE ID)

REMOTE ID ID1
Change the unit's remote control ID so that it matches the remote control's ID (default:
ID1). When using multiple Yamaha AV receivers, you can set each remote control with a
unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
■
Changing the remote control ID of the remote control
Perform each of the following steps within 1 minute. Otherwise, the setting will be
automatically canceled.
1
Press CODE SET on the remote control.
2
Press RECEIVER.
3
Use the numeric keys to enter "5019" (ID1) or "5020" (ID2).
Once the remote control ID is registered successfully, SOURCE blinks twice.
If it blinks six times, registration failed. Repeat from Step 1.
• The registered remote control codes (p.108) are not cleared even if you change the remote control ID.

Switching the video signal type (TV FORMAT)

TV FORMAT NTSC
Switch the video signal type of the unit so that it matches to the format of your TV.
Settings
NTSC, PAL
Default
U.S.A. model: NTSC
Other models: PAL
Removing the limitation on HDMI video output
(MON.CHK)
MON.CHK YES
The unit automatically detects resolutions supported by a TV connected to the HDMI
OUT jack.
Disable the monitor check function if you want to specify a resolution in "Resolution"
(p.95) when the unit cannot detect the TV's resolution or when you want to specify a
different resolution than the detected resolution.
Settings
Enables the monitor check function. (Outputs video signals with a
YES (default)
resolution supported by the TV only.)
Disables the monitor check function. (Outputs video signals with a
SKIP
specified resolution regardless of compatibility with the TV.)
• Reset to "YES" if the unit becomes inoperable because video from the unit cannot be displayed on the TV
after "MON.CHK" has been set to "SKIP".

Restoring the default settings (INIT)

INIT CANCEL
Restores the default settings for the unit.
Choices
VIDEO Restores the default settings for video configurations.
ALL Restores the default settings for the unit.
CANCEL Does not perform an initialization.
CONFIGURATIONS ➤ Configuring the system settings (ADVANCED SETUP menu)
106
En