Optional Accessories; Protecting The Environment - DeWalt D26410 Original Instructions Manual

english
Replacing the Dustbag (Fig. E)
For efficient dust extraction replace the dustbag
when it is about one third full.
1. Carefully pull the dustbag opening (12) off the
frame outlet (13) and remove the dustbag (8).
2. Fit a new dustbag following the instructions as
described above.
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Replacing the Sanding Pad and the
Speed Limiter Disc (Fig. F)
Both the sanding pad (5) and the speed limiter disc
(15) are consumable parts. The sanding pad needs
replacement when signs of wear become evident.
The speed limiter disc needs replacement when the
sanding pad speed increases dramatically when
lifting the sander off the workpiece.
1. Unplug the tool.
2. Loosen the hex screw (14) and remove the
pad.
3. Replace the sanding pad (5) and/or speed
limiter disc (15), and tighten the Hex screw (14),
making sure the speed limiter disc is aligned
properly.
Lubrication
Your power tool requires no additional lubrication.
22
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
• After the tool is used in metal sanding
applications without dustbag, clean the tool
using low-pressure air.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
been tested with this product, use of
such accessories with this tool could be
hazardous. To reduce the risk of injury,
only D WALT recommended accessories
e
should be used with this product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. Products and
batteries marked with this symbol
must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for
raw materials. Please recycle electrical products
and batteries according to local provisions. Further
information is available at www.2helpU.com.
WALT, have not
e