Black & Decker BAPUV250 Manual page 10

SET UP & USE
Air Quality Indicator
Air quality Indicator (PM2.5) will adjust based on the air quality in the environment.
Blue 0-50
Green 50-100
Purple 100-150 Normal
Red 150-
Filter Replacement Light
WARNING: Unplug unit before replacing filters.
After 1,600 hours of use, the REPLACE FILTER
and flash. Replace the 2 HEPA filters and 2 Activated Carbon filters. After the filters
have been replaced, touch the RESET
FILTER indicator light will turn off and the other control panel lights will illuminate.
NOTE: Refer to CLEANING AND MAINTENANCE section of this manual for
information about how to access and install the filter.
To shut OFF the unit at any time, touch POWER
other indicator lights off. Unplug the unit.
WARNING: Do not run the unit without the filters in place.
Remote Control:
Air purifier can be operated using the remote control.
1. To turn the unit on, press the ON/OFF
2. To operate fan speed low, medium or high on 1 (LOW), 2 (MEDIUM), 3 (HIGH) or
4 (MAX) press the FAN SPEED
speed is highlighted on the unit.
3. Press SILENT
4. Press AUTO
the air quality in the room.
5. Press TIMER
6. Press UV Lamp if you would like the UV Sensor activated.
7. Press RESET
Page 10
Excellent
Good
Poor
mode if you would like the fan speed on lowest option.
A
if you would like the fan speed to automatically set according to
if you would like to choose 1, 4 or 8 hour option.
after you replace the filters. Hold for 5 seconds.
indicator light will illuminate red
button for 5 seconds to reset. The REPLACE
and it will illuminate red with
Button.
button. Continue to press until the appropriate