Keys Of Remote Controller - Haier L26V6-A8 Owner's Manual

The remote controller cannot be operated unless the batteries are
properly loaded.
MUTE STILL
SLEEP PIP
SCAN
TV/AV
P.STD
CH+
VOL- MENU
CH-
CH.LIST TIMER ZOOM
20. Lock button(enter the Lock Set menu)
23. Channel list button, press to display the program that we had stored
24. Press to exit OSD menu
25. Timer display(only when there is teletext in TV signal)
26. Adjust picture aspect ratio

Keys of remote controller

1.STILL:Press this key to freeze-frame the
current screen and press again to continue
playing
2.I/II :TV audio mode selection
3.MUTE:Press to mute the sound and again
to reactivate the sound.Sound also reactivate
DISPLAY
if the power off then on or the volume level
is changed
4.Press to switch off the TV to standby mode
but can not turn on the TV by this button)
5.SCAN:Use the key to let the television auto-
matically scan all preconcerted channel.
6.DISPLAY:Display ON/OFF
SWAP
7.Sleep: Used to set time to change the TV
into the standby status after period of preset
S.STD
time
8.PIP(No available)
9.Digits
Program direct option(when edit prog-
VOL+
ram,every press can set different sign
by turns among the digits and sign on top
of them),also press these buttons to turn
on the TV from standby mode .
10.TV/AV : Press to display input source
11. SWAP
H.LOCK
EXIT
12.P.STD (Picture mode option)
13.S.STD (Sound mode option)
14.Program up and down, sound
increase and decrease, menu,
menu reset and back to the superst-
ratum . Also, you could press CH+/- to
turn on the TV from standby mode .
15-26 . Teletext buttons( buttons which have
letters on top also can be used in TV signal)
Switch the current channel to the last
channel you have viewed.
English-8