Kenwood Chefette Mary Berry HM680 Series Instructions Manual page 7

vinegar to remove limescale. Keep away
from heat (cooker tops, ovens, microwaves).
before plugging in
Make sure your electricity supply is the same as the one shown on the rear of
l
your handmixer.
No action is required to switch between 50Hz and 60Hz
l
Important – Plug and Fuse Information
The wires in the cord are coloured as follows:
l
Blue = Neutral
Brown = Live.
If the plug supplied with your appliance has a fuse fitted it is rated 3A. If the
l
fuse fails it must be replaced with one of the same rating.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when replacing
l
the fuse. If the fuse cover is lost then the plug must not be used until a
replacement can be obtained. The correct fuse cover is identified by colour
and a replacement may be obtained from your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY.
l
An electric shock hazard may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
This appliance conforms to EC Regulation 1935/2004 on materials and
l
articles intended to come into contact with food.
before using your handmixer
for the first time
Wash the parts (see 'cleaning').
l
key
a speed switch
b tool release button
c mixer
d beaters
e kneaders
f spatula
g splash guard
h mixing bowl
i mixer release switch
j cord wrap
k cradle release switch
l cradle
m stand
to use your handmixer
Unwrap the cord from the cord wrap
l
j before use.
1 Insert the mixer into the cradle and
push down to locate 1.
To remove, press the mixer release
l
switch i whilst lifting the mixer out
of the cradle.
2 Push down the cradle release switch
k and swing the mixer upwards on
the stand 2.
3 Place the ingredients into the mixing
bowl and then place the bowl on to
the stand.
4 Insert the beaters or kneaders into
the mixer – turn until a positive click
is felt 3.
If using the mixer with stand, insert
l
the beater/kneader with the plastic
gear ensuring it aligns with the drive
gear on the cradle.
If using the mixer without the stand,
l
the beater/kneader with the plastic
gear must be inserted into the
socket with the metal ring.
The beaters/kneaders can only be
l
removed when the speed switch a
is in the off "O" position.
5 Attach the splash guard, if desired
4. With the cradle raised, slide the
splashguard into the front until fully
located.
6 Steady the stand with one hand
and lower the cradle/mixer with the
other. Do not use the cradle
release switch.
7 Plug in.
4