Table of Contents
Advertisement
Multiple RC Support
If OFF is selected TV will go on normal operation. If It is ON RCU type (system code) that is chosen in "RCU
program menu" will be used. "RCU program menu" can be opened by RETURN-1-2-3-4 shortcut. Note: For any
MHEG supporting services sequence should be INFO-RETURN-1-2-3-4. The multiple RC support is works on RC5
type of remote controllers. To active this feauters, the hotel mode should be active and from the hotel mode
configuration menu, Multiple RC support should be set as ON.
Welcome message
As default behaviour a welcome message image will be displayed (if hotel mode is enabled). The image will stay
on screen until user presses a key. On the bottom side of image there is an message (osd message) displaying
"press any key". Welcome image can be changed through USB (described in "copy from USB" section). A default
welcome image is available. Welcome images are png files with the resolution of 960X540.
Signal Lost (no signal) message
As default behaviour, if there is no signal the same welcome image is displayed. This time osd message is "no
signal".
Internal Clock
If hotel mode is active a new function (add wake up timer) will be available in Settings/Timers menu. That function
will open a new menu to set wake up time. After timer is saved tv can wake up automatically on desired time.
If alarm option was selected as "on" after wake up tv will show welcome image and an alarm will be heared. Then
any key will stop alarm and welcome image. If alarm option was selected as "off" after wake up tv will not show
welcome image and the alarm will not be activated.
There is a "wakeup time channel" option in hotel mode menu, Its used to set the channel, whose time information
to be used for wakeup timer. If this option is "0" time information of the channel which is being watched when timer
menu is opened, will be used. Otherwise a "please wait" message will be displayed before the menu is open and
during "please wait" time information of the channel will be get. (This can take up to 30s). The "wakeup time
channel" should be a digital service.
Pin8
If ON is selected Pin8 will go on normal operation. If It is OFF Pin8 ignored.
NIT Update
Enables/disables NIT (i.e. Network Information Table) updates. Default value is ON.
EPG enable/disable
Enables/disables EPG (Electronic Program Guide) function.
Reset to Default Values
This resets all option of Hotel TV Menu to their default values.
RC Key System Code
1
1
2
0
3
2
4
3
13
Advertisement
Table of Contents
