Table of Contents
Advertisement
16
en | System setup - first steps
5.
6.
7.
8.
9.
10. Click the Set time zone, Configure networking and Provide computer name and domain
11. Press CTR+ALT+DELETE. The Windows logon page is displayed.
12. Enter the password.
13. Double-click the Bosch VMS Wizard icon
14. Configure the system using the Configuration Wizard.
Notice!
If the IP addresses of devices that should be added don't fall within the same IP range as the
DIVAR IP we recommend using the Bosch VMS Configuration Client. In all other cases use the
Configuration Wizard.
Notice!
To perform administrative tasks, the BVRAdmin account can be entered when Bosch VMS
default screen is displayed. To do so, press CTRL+ALT+DEL, then hold down SHIFT while
clicking the Switch User option and keep SHIFT pressed for about five seconds.
See also:
–
–
–
4.4
Using Configuration Wizard
Intended use for Configuration Wizard is the quick and easy configuration of a smaller system.
Configuration Wizard helps you to achieve a configured system including VRM, iSCSI system,
cameras, recording profiles and user groups.
User groups and their permissions are configured automatically. You can add or remove users
and set passwords.
Configuration Wizard can access Management Server only on the local computer.
You can save an activated configuration for backup purposes and import this configuration
later. You can change this imported configuration after import.
Configuration Wizard adds the local VRM automatically.
Restrictions:
The following tasks cannot be done with the Configuration Wizard. Use Bosch VMS
Configuration Client instead.
2013.10 | V1 | DOC
Accept the license terms, then click Start. Windows restarts.
After restart is finished, press CTR+ALT+DELETE. The Windows logon page is displayed.
Enter the default password WSS4Bosch.
After entering the password, a message is displayed that you must change the password
before logging on the first time. To confirm, click OK.
Change the password.
A series of scripts perform important setup tasks. This can take several minutes. Do not
turn off the computer.
A page is displayed where you can perform initial Windows configuration tasks.
Note: In case of password loss a system recovery must be performed as described in the
installation manual. The configuration must be done from scratch or must be imported.
link, enter the appropriate information, then click Close. Windows restarts.
The Bosch VMS default screen is displayed.
The Welcome page is displayed.
Using Configuration Wizard, page 16
Using Bosch VMS Configuration Client, page 27
Additional documentation and client software, page 29
Quick Installation Guide
to start the Configuration Wizard.
Bosch Sicherheitssysteme GmbH
DIVAR IP 7000 1U
Advertisement
Table of Contents
