Table of Contents
Advertisement
1.
Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01860]
2.
Start the engine. Warm it up and keep the
idle speed for 5-10 minutes.
3.
Stop the engine and leave it for 5-10 min-
utes.
4.
Remove the top cowling.
5.
Remove the oil filler cap. Pull out the dip-
stick and use the oil changer to extract
the oil completely.
1. Oil changer
6.
Add the correct amount of oil through the
filler hole. Put back the filler cap and the
dipstick. NOTICE: Overfilling the oil
could cause leakage or damage. If the
oil level is above the upper level mark,
drain until the level meets the speci-
fied capacity.
[ECM01850]
1. Oil filler cap
Recommended engine oil:
4-stroke outboard motor oil
Total engine oil quantity (oil pan capaci-
ty):
Without oil filter replacement:
5.6 L (5.92 US qt, 4.93 Imp.qt)
With oil filter replacement:
5.8 L (6.13 US qt, 5.10 Imp.qt)
Replacement engine oil quantity (at peri-
odic maintenance):
Without oil filter replacement:
4.5 L (4.76 US qt, 3.96 Imp.qt)
With oil filter replacement:
4.7 L (4.97 US qt, 4.14 Imp.qt)
7.
Leave the outboard motor for 5-10 min-
utes.
8.
Remove oil dipstick and wipe it clean.
9.
Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
Maintenance
73
Advertisement
Table of Contents
