Installation Procedure 1. To prevent a short circuit, remove the key from the 2WARNING ignition and disconnect the - battery. If you connect the ignition wire (red) and the battery wire 2. Make the proper input and output wire connections for (yellow) to the car chassis (ground), you may cause a short each unit.
Page 4
Connection 2WARNING If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. FM/AM antenna input Connect to the vehicle's parking brake detection switch harness using the supplied relay connector.
Page 5
(Accessory 1) Mute wire (Brown) Connect to the terminal that is grounded when either the telephone MUTE rings or during conversation. NOTE To connect the KENWOOD navigation system, consult your navigation manual. White/Black ILLUMI To front left speaker White Gray/Black...
Connection System Connection To TV Tuner unit To Navigation System To DSP unit To Disc Changer etc. Optical input for DSP unit 2CAUTION Wire an optical cable after fixing it with the clamp on the back of the unit. Do not bend the optical cable within a minimum radius of 30 mm, or it may be damaged.
Installation Installation for Monitor/Player Unit Firewall or metal support Screw (M4X8) (commercially available) Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Self-tapping screw (commercially available) Metal mounting strap Accessory 4 (commercially available) Make sure that the unit is installed securely in place.
Page 8
Installation Installing in Japanese-Made Cars Accessory 6 or 7 Bracket Accessory 6 or 7 Accessory 3 (For NISSAN Car) 8 English Downloaded from: http://www.usersmanualguide.com/...
Page 9
Removing Monitor/Player Unit ■ Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 5 and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the Catch Lock figure.
Page 26
설치 기 설치 기 설치 기 전에 전에 전에 전에 설치 기 설치 기 전에 부속품 부속품 부속품 부속품 부속품 ....1 ....2 ....1 ....6 ....1 ....6 ....1 26 한 한 한 한 한 글 글 글 글 글 Downloaded from: http://www.usersmanualguide.com/...
Page 27
설치 설치 설치 설치 설치 순서 순서 순서 순서 순서 1. 단 을 방 기 위해 이그니션에서 키를 빼고 - 룭터리 2경고 를 단 니 . 이그니션 와이어 (빨강) 와 룭터리 와이어 ( 랑) 를 대 ( 기기의 출렋 와이어를 룞르게 니...
Page 28
접속 접속 접속 접속 접속 2경고 이그니션 와이어 (빨강) 와 룭터리 와이어 ( 랑) 를 대 ( ) 에 연결할 때에 전기 누전을 일으켜 발 할 도 있습니 . 이들 와이어는 항상 휴즈 룟스를 관통 는 전원 스에 연결 십 오.
Page 29
(부 품 1) 뮤트 룭선 (갈 ) 전 출 또는 대 중 된 단 에 니 . MUTE 주의 KENWOOD 비게이션 스템을 연결 기위해서는 비게이션 메뉴얼을 참조 십 오. 흰 /검은 ILLUMI 앞 왼쪽 스피커 흰 회 /검은 앞 오른쪽 스피커...
Page 30
접속 접속 접속 접속 접속 시스템 시스템 시스템 연결 시스템 시스템 연결 연결 연결 연결 네비게이션 네비게이션 시스템으로 시스템으로 네비게이션 네비게이션 네비게이션 시스템으로 시스템으로 시스템으로 TV 튜너 튜너 튜너 튜너 튜너 기기로 기기로 기기로 기기로 기기로 기기로 기기로 DSP 기기로 기기로...
Page 31
설치 설치 설치 설치 설치 모니터 모니터 모니터 모니터 모니터/ / / / / 플레이어 플레이어 플레이어 플레이어 플레이어 기기를 기기를 기기를 기기를 위한 기기를 위한 위한 위한 위한 설치 설치 설치 설치 설치 방 벽 또는 메탈 서 트 나...
Page 32
설치 설치 설치 설치 설치 일제 일제 일제 자동차에 일제 일제 자동차에 자동차에 자동차에 자동차에 설치 기 설치 기 설치 기 설치 기 설치 기 부 품 6 또는 7 브래킷 나 (오디오 기기 패키 에 부 품 6 또는 7 부...
Page 33
모니터 모니터 모니터 모니터 모니터/ / / / / 플레이어 플레이어 플레이어 플레이어 플레이어 기기 기기 기기 기기 떼어내기 기기 떼어내기 떼어내기 떼어내기 떼어내기 강화 강화 고무 고무 프레 프레 떼어내기 떼어내기 ■ 강화 강화 강화 고무 고무 고무 프레 프레...
Page 37
This file has been downloaded from: www.UsersManualGuide.com User Manual and User Guide for many equipments like mobile phones, photo cameras, monther board, monitors, software, tv, dvd, and othes.. Manual users, user manuals, user guide manual, owners manual, instruction manual, manual owner, manual owner's, manual guide, manual operation, operating manual, user's manual, operating instructions, manual operators, manual operator, manual product, documentation manual, user maintenance, brochure, user reference, pdf manual Downloaded from:...