Setup; Removing The Mower From The Carton; Checking The Wheel Hubs And Installing The Wheels - Toro ReelMaster 01005 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Media and Additional Parts
Description
Parts Catalog
Operator's Manual
Note: Determine the left and right sides of the machine from the normal operating position.
1
Removing the Mower from the
Carton
No Parts Required
Procedure
1. Slit the four corners of the carton so the sides lie flat.
2. Remove the shipping caps from the wheel hubs.
Note: Keep the shipping caps. They can be installed
on wheel hubs to prevent grinding dust from entering
wheel bearing whenever reel is ground.
Description
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
Qty.
–
–
–
–
–
–
Qty.
1
Review the material and save in an appropriate place.
1
2
Checking the Wheel Hubs and
Installing the Wheels
No Parts Required
Procedure
1. Rotate the wheel hub (Figure 2) to check the bearing
adjustment. A slight drag must be felt when the hub is
rotated. If drag is not evident, tighten the wheel hub
nut (Figure 2) until slight drag is felt when the hub is
rotated.
4
Use
Remove the mower from the carton
Check the wheel hubs and install the
wheels
Check the gear case oil
Check the reel bearings and mower
fasteners
Parallel the bedknife to the reel
Set the height of cut
Use