Advertisement
1. Led panel
2. Heating power light
3. Steam buttons button
4. Steam push button
5. Water tank
6. Fabric Brush
7. Lint brush
8. Nozzle
Before to use:
Clean with a soft damp cloth.
During first uses a small smoke emission may occur, that's normal;
1. Filling water:
• Ensure appliance is unplug, remove the water tank by pushing tank release button
• Remove water inlet stopper to fill it with 300ml of water
NOTE
Your appliance was designed to operate using pure demineralized water
• Close the water inlet stopper
• Return the water tank to its place
Tips: Check the fabric's label for recommendations.
• We recommended that you test acrylic, nylon or other synthetic fabrics in an inconspicuous area to
ensure these fabrics are not damaged by hot steam
• As steam is very hot: never attempt to remove creases from a garment while it is being worn, always
hang garments on a clothes hanger.
2. Hang your garment on a clothes hanger
3. Plug-in the appliance, push the power on, the power light is flashing. The appliance heat up. After
30s, the power light will be lighting.
4. You can use the brush accessory to open better the weaves of the fabrics for better steam effect. And
you can use the lint brush too.
Note: before removing or attaching the steam brush, unplug your appliance and allow it to cool
down.
5. Push the power again to choose the steam level, then slide the steam button facing away from you,
Instruction manual
DESCRIPTION
USE
7
Advertisement
