Electrical Connection; Changing Door Stop - AEG 7040 TWF User Manual

1. Open loading door
2. Pull off adhesive strips from inside ap-
pliance on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the appliance.

Electrical connection

Details on mains voltage, type of current and the fuses required should be taken from the
type plate. The type plate is fitted near the loading aperture (see "Product description"
chapter).
Connect the machine to an earthed socket, in accordance with current wiring regu-
lations.
WARNING!
The manufacturer declines any responsibility for damage or injury through failure
to comply with the above safety precautions.
Should the appliance power supply cable need to be replaced, this must be carried
out by our Service Center.
WARNING!
The plug must be accessible after installing the machine.

Changing door stop

WARNING!
Before changing the door stop, disconnect the mains plug.
1. Open loading door.
Unscrew hinge A from the front of the
2.
appliance and take off the loading door.
Remove cover plates B. To do this, insert
3.
a thin screwdriver into the slots as
shown in the illustration, push down-
wards slightly and pry out the cover
plates.
Use an appropriate tool and exert pressure to unfasten locking block C from the snap-
4.
on fixture, take out and re-insert on the other side having rotated the block through
180°.
Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite
5.
side and screw down.
Re-insert cover plates Bon the opposite site having first rotated them through 180°.
6.
Installation
A
B
C
B
A
33