Kenwood VT-171 Instruction Manual page 9

(3) dBm Scale
In general, voltmeters have a reference level division
of OdBm equal to 0.775V (1 mV power) induced across
a 600O resistance load. Therefore, the red dBm scale
is a v a i l a b l e to measure a power level referenced to 0
d B m , w i t h the impedance of the given power circuit
being 60012 pure resistance. Where measured across
specific resistance loads, for example, 1 0 k O
than the 600X1 load, the levels are sometimes
expressed in d B s .
• How to Use Remote Control
A v a i l a b i l i t y of the optional Remote Control is one of
outstanding features of your V T - 1 7 1 [ " V T - 1 7 1 E J .
T o attach the Remote C o n t r o l , remove the blind plate
a t the rear of your V T - 1 7 1 ( " V T - 1 7 1 E J . Install and
plug the optional con-nector into the 16-pin connector
on the P C board.
The R T - 6 1 option, a remarkable feature of the V T - 1 7 1 ,
provides a remote control capability. T o use the option,
remove the case and the rear-panel blind plate, install
the connector supplied w i t h the R T - 6 1 , then plug the
R T - 6 1 into the 16-pin connector on the print circuit
board. F o r details, refer to the R T - 6 1 Instruction
M a n u a l .
How to Use Relative Reference Control
The R E L A T I V E R E F control is kept a t " C A L " in
general cases of reading calibrated, absolute values on
the Meter. T o measure relative levels such a s fre-
quency responses, turn the control for
s t a t e ( U N C A L ) until the reference level is set to a
desired value, for example, OdBm. T h i s a l l o w s reading
other
the relative levels.
r
Figure 4 - Meter Scale G r a d u a t i o n s .
uncalibration
®