Advertisement
4. USING THE SCAN TOOL
4.1.
LOCATION OF THE DLC
4.1.1.
The DLC (Data Link Connector or Diagnostic Link Connector) is the standardized 16-cavity connector where diagnostic scan tools
interface with the vehicle's on-board computer. The DLC is usually located 300mm from the center of the instrument panel (dash),
under or around the driver's side for most vehicles. If Data Link Connector is not located under dashboard, a label should be there
telling the location. For some Asian and European vehicles, the DLC is located behind the ashtray and the ashtray must be
removed to access the connector. If the DLC cannot be found, refer to the vehicle's service manual for the location.
4.2.
TOOL DESCRIPTION
4.3.
FUNCTION DESCRIPTION
4.3.1.
Dual-system diagnostic fault detection, option of either engine or transmission selection.
4.3.2.
Quick indication of engine faults. LED light fault indicators in GREEN / YELLOW / RED.
4.3.3.
The option to read or clear engine fault codes: 16929 diagnostic fault code defi nitions can be tested.
4.3.4.
Dynamic display of sensor data stream information, utilising 249 types of sensors.
4.3.5.
View freeze frame data and I/M status information.
4.3.6.
Read vehicle information:
Vehicle identification number (VIN)
Calibration identification number (IDs)
Calibration verification number (CVNs)
4.3.7.
Diagnostic fault detection tests for the cranking and charging systems of the vehicle.
4.3.8.
Multi-language option.
5. TOOL SETTINGS
5.1.
SETUP
5.1.1.
Language:
Selects desired language.
English is the factory default setting.
From language screen select language required.
5.1.2.
Unit of measure:
Selects desired measurement unit.
Metric is the factory default setting.
From measurement screen select measurement unit required (metric or imperial).
5.1.3.
Fn Key Set:
The Fn key can be set up as a one click quick test function, and can be used in the following modes:
Usual Datastream - All Datastream - I/M Readiness - Read Codes.
6. DIAGNOSTIC
6.1.
DUAL-SYSTEM SELECTION
6.1.1.
Start the car's engine and plug the OBD II connector into the vehicle's Date Link Connector (DLC).
6.1.2.
Enter the reader's main interface, and click the ENTER key to start scanning the vehicle (DLC) system.
6.1.3.
By default the reader will select the single engine system.
6.1.4.
The dual system selection menu will display when detected.
6.1.5.
Select the system to be diagnosed.
(1) $ 7E8: Engine ............................................Engine system
(2) $ 7E9: A/T ........................................Transmission system
© Jack Sealey Limited
1
LCD Display
Red LED: indicates an engine problem. The Malfunctioning Indicator Light
2
may be on (MIL)
Yellow LED: indicates a possible problem. Some diagnostics could not be
3
performed and/or a DTC is pending
4
Green LED: indicates that engine systems are"OK" and operating normally
5
Fn key
6
Back or exit key
7
OBD II connector
8
Up key
9
Enter key
10
Down key
Original Language Version
Display Description
VS8812.V2 Issue 1 18/06/21
Advertisement
