Advertisement
Quick Links
Blower and Drive Kit
48in, 52in, 60in or 72in E-Z Vac™ for Z Master
Model No. 78551—Serial No. 290000001 and Up
Model No. 78552—Serial No. 290000001 and Up
Model No. 78553—Serial No. 290000001 and Up
Model No. 78554—Serial No. 290000001 and Up
This product contains a chemical or chemicals known to the State of California to
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Description
No parts required
No parts required
Pulley assembly
Belt cover bracket
Carriage bolt (1/4 x 3/4 inches)
Locknut (1/4 inch)
Belt cover bracket
Carriage bolt (1/4 x 3/4 inches)
Locknut (1/4 inch)
Blower assembly
Bagger belt
Blower belt cover
Spring
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
–
1
1
2
2
1
2
2
1
1
1
1
Form No. 3371-270 Rev D
®
Riding Mower
Installation Instructions
Use
Prepare the mower.
Remove the existing belt cover, belt,
and bracket.
Install the pulley assembly and belt.
Install the new belt cover bracket for 48-
and 52-inch mowers.
Install the new belt cover bracket for 60-
and 72-inch mowers.
Install the blower, bagger belt, spring,
and belt cover.
Original Instructions (EN)
All Rights Reserved *3371-270* D
Printed in the USA
Advertisement
Related Manuals for Toro 78551
Summary of Contents for Toro 78551
- Page 1 48in, 52in, 60in or 72in E-Z Vac™ for Z Master ® Riding Mower Model No. 78551—Serial No. 290000001 and Up Model No. 78552—Serial No. 290000001 and Up Model No. 78553—Serial No. 290000001 and Up Model No. 78554—Serial No. 290000001 and Up...
- Page 2 Preparing the Mower Removing the Existing Belt Cover, Belt, and Bracket No Parts Required No Parts Required Procedure Procedure Perform the following procedure to prepare the mower for attaching the blower and finishing kit. Note: Clean the area around the belt cover before removing. 1.
- Page 3 Note: Torque the bolts to 28 to 34 N-m (21 to 25 4. Remove the existing right belt cover bracket (Figure Figure ft-lb). Figure 3 60- and 72-inch mower deck shown 1. Right belt cover bracket 3. Flange nut 2. Washer 5.
- Page 4 For Units without Bolts 1. Remove the nuts on the existing mower-deck pulley (Figure 2. Install the new pulley assembly onto the mower-deck Installing the New Belt Cover pulley bolts (Figure Bracket 3. Turn the pulley to lock it into position (Figure 4.
- Page 5 Installing the New Belt Cover Installing the Blower Bracket Assembly, Bagger Belt, Spring and Blower-Belt Cover 60- and 72-inch Mowers Parts needed for this procedure: Parts needed for this procedure: Blower assembly Belt cover bracket Bagger belt Carriage bolt (1/4 x 3/4 inches) Blower belt cover Locknut (1/4 inch) Spring...
- Page 6 Notes:...
- Page 7 Notes:...