Advertisement
3 - 2
R E A R
P A N E L
©
T O S C O P E
t e r m i n a l
Outputs A C voltage in proportion to wow and
f l u t t e r .
If the meter reads the f u l l scale value,
approx.
I V r m s is output, which s l i g h t l y
w i t h standards.
Output
Use t h i s terminal f o r w a v e f o r m observation or
frequency a n a l y s i s .
©
O S C 3 k / 3 . 1 5 k terminal
Outputs the sine wave for recording a t a f r e -
quency selected w i t h the O S C selector s w i t c h
Output
voltage is approx. 0 . 2 V r m s .
impedance is 60012.
Use this signal to measure wow and f l u t t e r
tape recorders, etc. in accordance w i t h
standard.
©
R E C O R D E R
t e r m i n a l
Outputs D C voltage in proportion to the meter
reading when measuring wow and f l u t t e r .
If the meter reads the f u l l scale value, output
voltage is approx. 1V.
60011.
d i f f e r s
impedance is 60012.
Output
Distortion
is 1% or
less.
the
Output
impedance is
©
Supply voltage selector / Fuse holder
Set this switch to the supply voltage used.
A 0.3A fuse is built in for the 100/120V areas.
If this meter is used in the 200/240V area,
replace the fuse w i t h a 0.2A fuse.
Note : Do not use an improper
© .
of
fuse.
9
Advertisement
