Advertisement
8199-201909
Installing the battery
The display unit needs to be removed and installed for
changing the battery.
• Remove the two display bolts on back side of the
Clamp
clamp, and then remove the display unit.
• When installing the display unit, tighten the two display
bolts from the back side of the clamp.
WARNING
Tighten the display bolts to 1.5–2.5 N·m (0.15–0.25
kgf·m, 1.1–1.8 lb·ft). Otherwise, during riding, vibra-
Display bolt
tion could cause the display bolts to come loose with
the risk that the display unit may fall off. A loose dis-
play could distract the rider or interfere with control.
Battery
Check if the rated battery (CR2032) is installed in the rear
of the display unit.
If a battery is not installed, or if there is not sufficient bat-
Cover
tery power remaining, install a new battery.
O-ring
To adjust the time, see "Stopwatch and settings".
TIP
• Make sure that the O-ring is installed correctly.
• Use a new type CR2032 button cell battery (sold sepa-
rately).
• When a battery is drained, whenever it turns on the ve-
hicle power supply, the clock begins to count from
11:00. Please replace the battery, if such a condition
appears.
Advertisement
