Product Introduction - Mitsubishi Electric MAC-558IF-E Installation Manual

(Improper handling may have consequences, including injury or damage to house.)
• To prevent damage from static electricity, touch a
nearby metal body to discharge static electricity
from yourself before touching the Wi-Fi adaptor.
• Static electricity from the human body may
damage the Wi-Fi adaptor unit.
• Do not install the Wi-Fi adaptor in a place with
much steam, such as bathroom.
• Avoid places where water is splashed or where
condensation forms on walls. Installing in such
places can cause electric shock or breakdown.
• Do not install the Wi-Fi adaptor in places
with direct sunlight or where the ambient
temperature is 40ºC or more or is 0ºC or less.
Direct sunlight and high or low temperature
environments may cause the Wi-Fi adaptor to
deform or breakdown.
• Please ensure that the access point supports
both WPS connection and the WPA2-AES
encryption setting before commencement of the
installation of the MAC-558IF-E.
• The end user should read and accept the
terms and conditions of the Wi-Fi service before
commencement of the installation of
MAC-558IF-E.
• To complete connection of the MAC-558IF-E to
the Wi-Fi service physical access to the access
point may be required.
Mitsubishi Electric's Wi-Fi adaptor is designed for communication to Mitsubishi Electric's Wi-Fi service.
Third party Wi-Fi adaptor cannot connect to Mitsubishi Electric's Wi-Fi service.
Mitsubishi Electric is not responsible for any (i) under performance of a system or any product;
(ii) system or product fault; or (iii) loss or damage to any system or product; which is caused by or arises
from connection to and/or use of any third party Wi-Fi adaptor or any third party Wi-Fi service with
Mitsubishi Electric equipment.
For the latest information regarding Wi-Fi control:
New Zealand based enquiries please visit www.mitsubishi-electric.co.nz/wifi
Australia based enquiries please visit www.mitsubishielectric.com.au/wifi

2. Product Introduction

No Item
1 WPS switch
2 RESET switch It resets the system and ALL settings
3 LED1 (Green)
4 LED2 (Orange) It shows the MAC-558IF-E state
5 LED3 (Green)
Description
It activates WPS
It shows the wireless communication state
It shows the local communication state
Caution
• Do not use in special environments.
• Do not use in places with much oil (including
machine oil), steam, or sulfuric gas - this may
lead to severe decrease in functionality and
damage to parts.
• Turn off power supply of connected equipment
when performing construction or wiring work.
• Failure to turn off the power supply to the
connected equipment may lead to malfunction
or breakdown of the Wi-Fi adaptor or connected
equipment.
• Dismantling the indoor unit
Please refer to the indoor units "service manual"
for detailed instructions for accessing the control
adaptor connector CN105 on the indoor unit
control PCB.
Note
• The MAC-558IF-E should not be installed
and connected to any Mitsubishi Electric
system which is to provide cooling or heating
to critical applications.
• Details of the air conditioner and MAC-558IF-E
can be recorded on page 2 'Setting Information'.
1
2
3
4
5
9