Download Print this page
Sealey CP72V Instructions

Sealey CP72V Instructions

Cordless caulking gun

Advertisement

Quick Links

thank you for purchasing a sealey product. Manufactured to a high standard this article will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEaSE REaD THESE inSTRuCTiOnS CaREFuLLY. nOTE THE SaFE OPERaTiOnaL REQuiREMEnTS, WaRningS anD
CauTiOnS. uSE THiS PRODuCT CORRECTLY anD WiTH CaRE FOR THE PuRPOSE FOR WHiCH iT iS inTEnDED. FaiLuRE TO DO SO MaY
CauSE DaMagE anD/OR PERSOnaL inJuRY anD WiLL inVaLiDaTE THE WaRRanTY. PLEaSE kEEP inSTRuCTiOnS SaFE FOR FuTuRE uSE.
1. SaFETY inSTRuCTiOnS
1.1.
gEnERaL SaFETY
 follow all workshop safety rules, regulations and conditions when using the gun.
remove the battery pack from the gun before servicing or performing any maintenance.
Maintain the gun and battery pack in good condition. check moving parts for alignment on a regular basis.
replace or repair damaged parts. Use an authorised service agent and recommended parts only. Unauthorised parts may be dangerous
and will invalidate the warranty.
Keep the gun, battery pack and charger clean for optimum performance.
use approved eye and ear protection.
Keep the work area clean and tidy and free from unrelated materials.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Keep children and unauthorised persons away from the work area.
Do not operate the gun if any parts are missing as this may cause failure and/or personal injury.
Do not operate the gun where there are solvent fumes or flammable gases, liquids or solids.
Do not use the gun for a task it is not designed to perform.
Do not operate the gun when you are tired or under the influence of alcohol, drugs or intoxicating medication.
Do not get the gun or battery charger wet or use in damp or wet locations.
Keep gun and charger in the case and store in a safe, dry, childproof area where the temperature will not exceed 104°f (40°c).
1.2.
BaTTERY SaFETY inSTRuCTiOnS
use only the charger provided to charge the battery pack.
Do not charge the battery pack when room temperature is below 50°f (10°c) or above 95°f (35°c).
Do not attempt recharging the pack by means of an engine generator or a Dc power source.
Do not short-circuit the battery pack by touching both terminals at the same time with a metal object, or your fingers etc.
Do not store battery pack (or gun) in locations where the temperature may exceed 104°f (40°c) e.g. in outside sheds, above heaters etc.
 DANGER! DO NOT attempt to disassemble the battery pack. For safety and environmental reasons DO NOT discard in domestic waste or
by burning. ONLY discard or recycle according to local authority regulations.
 WARNING! DO NOT allow a leaking battery to contact your person. If you come into contact with battery liquid take the following
immediate action:
1.3.
MainS POWER ELECTRiCaL SaFETY (in relation to the battery charger)
 WARNING! It is the user's/owner's responsibility to check the following:
You must check all electrical equipment and appliances to ensure that they are safe before using. You must inspect power supply leads,
plugs and all electrical connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of
appropriate safety devices. An rccB (residual current circuit Breaker) should be incorporated in the main distribution board. We
recommend that an rcD (residual current Device) is used with all electrical products. It is particularly important to use an rcD with
portable products that are plugged into a supply not protected by an rccB. If in doubt consult a qualified electrician. You may obtain an
rcD by contacting your local sealey dealer. You must also read and understand the following instructions concerning electrical safety.
1.3.1. the Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
person, using a Portable Appliance tester (PAt), at least once a year.
1.3.2. the Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.3.3. Do ensure that the insulation on all cables and the product itself is safe before connecting to the mains power supply. see 1.3.1.
above and use a Portable Appliance tester (PAt).
1.3.4. Do ensure that cables are always protected against short circuit and overload.
1.3.5. Do regularly inspect power supply leads, plugs and sockets for wear, damage or loose connections.
1.3.6. Do check that the voltage marked on the product is the same as the power supply to be used.
1.3.7. Do not pull or carry the appliance by the cables.
1.3.8. Do not pull the plug from the socket by the cable.
1.3.9. Do not use worn or damage leads, plugs or connections.
1.4.
BaTTERY CHaRgER SaFETY inSTRuCTiOnS
WaRning! DO nOT attempt to charge any battery other than that supplied for the gun. Other types of batteries may explode!
All mains electrical supply safety features must be followed as described in 1.3. above.
Disconnect the charger from the mains supply when not in use.
Do not charge battery if room temperature is below 41°f (5°c) or above 104°f (40°c)
Do not expose the charger to damp or wet conditions.
Do not pull or carry the charger by the power lead.
Do not operate the charger if it has been dropped, or has received a sharp knock, or is damaged. take the charger to an
authorised agent for repair or obtain a replacement.
Do not dismantle the charger as this may cause damage and/or personal injury and will invalidate the warranty.
Do not insert foreign objects or material into the hole reserved for the battery pack.
 a) Skin contact: Wash immediately with soap and water, then wash in either lemon juice or vinegar.
 b) Eye contact: Wash with a strong solution of boric acid and seek immediate medical attention.
InstructIons for:
CORDLESS CauLking gun
MoDEL no:
Original Language Version
CP72V
cP72V
Issue: 2 - 26/10/09

Advertisement

loading

Summary of Contents for Sealey CP72V

  • Page 1 CP72V MoDEL no: thank you for purchasing a sealey product. Manufactured to a high standard this article will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: PLEaSE REaD THESE inSTRuCTiOnS CaREFuLLY. nOTE THE SaFE OPERaTiOnaL REQuiREMEnTS, WaRningS anD CauTiOnS.
  • Page 2  Note: If two batteries are to be charged in succession allow the charger to cool between uses. tube Holder Plunger release switch Plunger trigger spare Battery charging Base Ac Adaptor Battery Original Language Version cP72V Issue: 2 - 26/10/09...
  • Page 3 WaRRanTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. inFORMaTiOn: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode. Sole uk Distributor, Sealey group, www.sealey.co.uk...
  • Page 4 It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. 01284 757500 Sole uk Distributor www.sealey.co.uk Sealey group, 01284 703534 sales@sealey.co.uk Bury st. Edmunds, suffolk. email cP72V - 1 - 011204...