DeWalt DCCS623 Instruction Manual page 18

English
DCCS623 TROUBLESHOOTING
BE sURE TO FOllOW sAFETY RUlEs AnD insTRUCTiOns
For assistance with your product, visit our website
at www.dewalt.com for a list of service centers,
or call D WALT at 1‑800‑4‑D
e
Problem Solution
Unit will not start. •
•
•
Unit shuts down •
in use.
•
Battery will •
not charge.
•
•
•
•
Bar / Chain •
overheated.
•
Chain is loose. •
Poor cut quality. •
Unit runs but does •
not cut.
Unit does not oil. •
•
16
WALT (1‑800‑433‑9258).
e
Check battery installation.
Check battery
charging requirements.
Check that lock off is fully
pushed down prior to moving
main trigger.
Charge battery.
Unit is being forced. Restart and
apply less pressure.
Insert battery into charger until red
charging light illuminates.
Plug charger into a working outlet.
Refer to Important Charging
Notes for more details.
Check current at receptacle by
plugging an appliance.
Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
Move charger and appliance to
a surrounding air temperature
of above 40 °F (4.5 °C) or below
104 °F (+40 °C).
Refer to Adjusting Chain
Tension section.
Refer to Chain Oiling section.
Refer to Adjusting Chain
Tension section.
Refer to Adjusting Chain
Tension section. nOTE: Excessive
tension leads to excessive wear
and reduction in life of bar and
chain. Lubricate before each
cut. Refer to Replacing the
Saw Chain and Saw Chain
Sharpening section.
Chain could be installed
backwards. Refer to sections for
installing and removing chain.
Refill oil reservoir.
Clean guide bar, sprocket
and sprocket cover. Refer to
Maintenance section.