Gpio-In Connector Mapping; Gpio-Out Connector Mapping - Dell Embedded Box PC 5000 Technical Manualbook

Features
10 Mobile broadband antenna port one
11 RS232/RS422/RS485 port three (configurable in
the BIOS)
12 RS232/RS422/RS485 port two (configurable in
the BIOS)
13 Wireless antenna port two
14 RS232/RS422/RS485 port one (configurable in
the BIOS)
15 Wireless antenna port one
1 The GPIO-in port has 9 pins. Pin labels are GND and GP10 through GP17.
2 Connections made to these ports must use SELV circuits and the wire (26 AWG-18 AWG) must have Double Insulation (DI) or Reinforced Insulation (RI) to
protect it from all hazardous voltages. Torque the screws at 2.88 kg-cm (2.5 lb-in) to secure the wire to the connector.
3 The GPIO-in port has 9 pins. Pin labels are GND and GP00 through GP07.
4 Connections made to the GPIO-in/out port must use SELV circuits (30 Vmax) and must be protected by Double/Reinforced Insulation (DI)/(RI) from all
hazardous voltages.

GPIO-in connector mapping

Pin
1
2
3
4
5

GPIO-out connector mapping

10
Signal
GPI0
GPI1
GPI2
GPI3
GPI4
Connect a mobile broadband antenna to increase the range
and strength of mobile broadband signals.
Connect an RS232/RS422/RS485 cable to the Embedded Box
PC. For more information, see
connector mapping.
Connect an RS232/RS422/RS485 cable to the Embedded Box
PC. For more information, see
connector mapping.
Connect a wireless antenna to increase the range and
strength of wireless signals.
Connect an RS232/RS422/RS485 cable to the Embedded Box
PC. For more information, see
connector mapping.
Connect a wireless antenna to increase the range and
strength of wireless signals.
Pin
6
7
8
9
RS232/RS422/RS485
RS232/RS422/RS485
RS232/RS422/RS485
Signal
GPI5
GPI6
GPI7
GND