Preparation For Operation; Contents Of Package; Introduction Of Section Function - Huawei CG1-2 Operating Instructions Manual

6.Cutting thickness
7.Bevel angle
8.Maximum fly past of web plate cutting
9.Maximum fly past of wing plate cutting
10.Maximum angle of wing plate slanting
cutting
11.Maximum angle of web plate slanting
cutting
9.Tip
10.Motor

Preparation for operation

3

3.1 Contents of package

Carefully take the machine out of its case. Check them carefully before assembling the
machine. The contents of the standard package are shown in the following list.
1）Body
2）Standard torch and sections
3）Wing plate mechanism
4）Tip（G02 or G03 ＃1，2、3， ）
5) Track(include track pressure plate)
6) Inlet gas joint
7）Spanner
8) Specification sheets and certificate of qualification
9) Power cable
10) M5 inner hexagon spanner
11) Phillips screwdriver
12) Needle

3.2 Introduction of section function

1) Quick distributor
Gas distributor uses integrated flame adjuster. Preheating flame and cutting oxygen are
adjusted once. After that, property of flame keeps same with adjusting rotating angle of
knob to turn on or off gas source when each cutting is finished.
Turn off position: cut off gas and oxygen
Preheating position: connect preheating flame and keep same
：5-50mm
：0～30°（ wing plate; web plate）
：A=1600mm
: B=800mm
:30°(maximum height of slanting cutting 690mm)
:35°(maximum length of slanting cutting 1300mm
:G02(for acetylene) or G03(for propane)
: 1) web plate motor 110V 50HZ 30W
Rotational speed,3600 rpm
: 2) wing plate motor 110V 50HZ 40W
Rotational speed,2200 rpm
- 7 -
CG1-2A H Beam cutter
1
1
1
1
1
1
1
1
1
1
1
1