Product Information; Declaration Of Conformity; Scope Of Delivery; Twin Combination - Bosch Climate 5000 L Installation Instructions Manual

2

Product Information

2.1

Declaration of conformity

The design and operating characteristics of this product comply with the
European and national requirements.
The CE marking declares that the product complies with all the
applicable EU legislation, which is stipulated by attaching this
marking.
The complete text of the Declaration of Conformity is available on the
Internet: www.bosch-climate.en.
2.2

Scope of delivery

The appliances are shown as an example and deviations are possible.
The scope of delivery of the possible appliances is shown in Fig. 1
and Fig. 2.
[1] Outdoor unit (filled with refrigerant)
[2] Indoor unit (filled with nitrogen)
[3] Display unit
[4] Wired room controller with fixing materials
[5] Button battery
[6] 2 plastic hoses and 4 cable ties for insulation
[7] Drainage elbow with gasket
[8] Magnetic ring (number depends on appliance type)
[9] Insulation piping
[10] Copper nut (2x)
[11] Set of printed documents for product documentation
[12] Extension cable for wired room controller (6 m)
[13] Extension cable for display unit (2 m)
[14] 4 anti-vibration couplings for the outdoor unit
[15] Remote controller
2.3

Twin combination

The appliances can be installed as so-called twin combination. In doing
so, an outdoor unit is combined with two indoor units of the same type.
The indoor units must be installed at the same height.
▶ Observe the possible combinations in table 2.
▶ Observe the dimensions in Fig. 29.
▶ Arrange the branch joints horizontally.
Outdoor unit
CL5000L 70 E
CL5000L 105 E/
CL5000L 105 E-3
CL5000L 140 E-3
CL5000L 160 E-3
Table 2 Possible twin combinations
2.4

Product dimensions and minimum clearances

2.4.1

Indoor unit and outdoor unit

Indoor Unit
Figs. 5 to 4.
[1] Connection for outside air duct
[2] Air inlet
[3] Air filter/air outlet
[4] Air filter/air outlet (following modification)
[5] Electric control box
Outdoor Unit
Fig. 6 to 7.
wired controller
 Fig. 23
Climate 5000 L • Climate 5000i U/L – 6721841493 (2022/05)
Indoor Unit
2 × CL5000iU D 35 E
2 × CL5000iU D 53 E
2 × CL5000iU D 70 E
2 × CL5000iL D 88 E
2.4.2

Refrigerant lines

Key to figure 8:
[1] Pipe on gas side
[2] Pipe on liquid side
[3] Siphon-shaped elbow as oil separator
If the indoor units are positioned lower than the outdoor unit, install a
siphon-shaped elbow on the gas side after no more than 6 m and every
6 m thereafter ( figure 8, [1]).
▶ Observe maximum pipe length and maximum difference in height
between indoor unit and outdoor unit.
Appliance type Maximum pipe
CL5000L 35 E
CL5000L 53 E
CL5000L 70 E
CL5000L 88 E
CL5000L 105 E
CL5000L 105 E-3
CL5000L 125 E
CL5000L 140 E-3
CL5000L 160 E-3
Table 3 Piping lengths
▶ Observe pipe diameter and further specifications.
Pipe diameter [mm]
6.35 (1/4")
9.53 (3/8")
12.7 (1/2")
15.9 (5/8")
Table 4 Alternative pipe diameter
Specification of the pipes
Min. piping length
Additional refrigerant to be added if the pipe
length exceeds 5 m (liquid side)
Pipe thickness with pipe diameter from
Ø 6.35 mm to 12.7 mm
Pipe thickness with 15.9 mm pipe diameter ≥ 1.0 mm
Thickness of insulation against heat
Material of insulation against heat
Table 5
2.5

Information on refrigerant

This device contains fluorinated greenhouse gases as refrigerant.
The device is hermetically sealed. You will find the information on the
refrigerant according to the Regulation (EU) No 517/2014 on
fluorinated greenhouse gases in the operating instructions of the device.
Information for the installer: If you refill refrigerant, enter the additional
charge size and the total charge size of the refrigerant in the table
"information on refrigerant" of the operating instructions.
Product Information
Maximum height
length difference [m]
[m]
≤ 25 ≤ 10
≤ 30 ≤ 20
≤ 50 ≤ 25
≤ 75 ≤ 30
Alternative pipe diameter [mm]
6
10
12
16
3 m
With Ø 6.35 mm (1/4"):
12 g/m
With Ø 9.53 mm (3/8"):
24 g/m
≥ 0.8 mm
≥ 6 mm
Polyethylene foam
55