Toshiba TWD-BM105GF4 Series Owner's Manual page 15

INSTALLATION
Levelling the Washer Dryer
Warning!
• The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached to the cabinet. If not, please turn them to
1.
their original positions and tighten the nuts.
2.Loosen the lock nut and turn the feet until it closely contacts with the floor.
3.Adjust the legs and lock them with a spanner, make sure the machine is steady.
Connect Water Inlet Hose
Warning!
• To prevent leakage or water damage, follow the instructions in this chapter
• Do not kink, crush, or modify water inlet hose.
Connect the water inlet hose as indicated, There are two ways to connect the water
inlet hose.
1.Connection between ordinary tap and water inlet hose.
clamp nut
Loosen clamp nut and
four bolts
2.Connection between screw tap and waterinlet hose.
Tap with threads and water inlet hose
1
Raise
1
Press the tap end
tightly to the rubber
ring inside the clamp,
and then, tighten the
4 bolts
2
Lower
2
slide bushing
Press slide bushing,
insert water inlet
hose into connecting
base
Special tap for washing machine
14
3
Lock nut
foot
!
3
Connection finished
slide bushing
4
4