1. Remove the idler pulley assembly from the left end of
the cutting unit and mount it to the lower hole in the
brush plate on the right end of the cutting unit
3).
Note: The idler pulley must pivot freely; do not over
tighten the locknut on the idler pivot bolt.
2. Remove the carriage bolt and nut and relocate them to
the upper hole previously occupied by the idler pulley
assembly
(Figure
3).
1. Idler pulley installation for
left end of reel
2. Idler pulley installation for
right end of reel
4
Removing the Brush Cover
Drain Plug
No Parts Required
Procedure
Remove only the bottom drain plug
covers. This allows moisture to drain from the belt area.
Figure 3
3. Carriage bolt and nut
4. Do not overtighten this
locknut.
(Figure
4) from the brush
(Figure
1. Brush cover
5
Installing the Roller Brush
Parts needed for this procedure:
1
Roller-brush housing
2
Allen-head bolt, 3/8 x 1 inch
1
Roller-brush assembly
1
Shoulder bolt
1
Belt cover/plate assembly
2
Bolt, 5/16 x 5/8 inch
1
Spacer
1
Drive pulley
1
Flange-head bolt, 3/8 x 2 inches
1
Belt
1
Shim washer (as required)
Procedure
1. Park the traction unit on a level surface and engage the
parking brake.
2. Ensure that the cutting units are disengaged. Turn
the engine off and remove the key. Remove all cutting
units from the traction unit.
Important: Check the cutting unit for the desired
height of cut and attitude. Reset it according to the
Operator's Manual , if required, before installing
the Rear Roller Brush Kit.
4
Figure 4
2. Bottom drain plug