DeWalt DCL510 Original Instructions Manual page 42

EngLIsh
• Do not use an extension cord unless it is absolutely necessary. Use of improper
extension cord could result in risk of fire,electric shock, or electrocution.
• Do not place any object on top of charger or place the charger on a soft surface
that might block the ventilation slots and result in excessive internal heat. Place
the charger in a position away from any heat source. The charger is ventilated through
slots in the top and the bottom of the housing.
• Do not operate charger with damaged cord or plug—have them
replaced immediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way. Take it to an authorised service centre.
Do not disassemble charger; take it to an authorised service centre when
•
service or repair is required. Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
• In case of damaged power supply cord the supply cord must be replaced immediately by
the manufacturer, its service agent or similar qualified person to prevent any hazard.
Disconnect the charger from the outlet before attempting any cleaning. This will
•
reduce the risk of electric shock. Removing the battery pack will not reduce this risk.
• NEVER attempt to connect two chargers together.
• The charger is designed to operate on standard 230V household electrical
power. Do not attempt to use it on any other voltage. This does not apply to the
vehicular charger.
Charging a Battery (Fig. C)
1. Plug the charger 8
2. Insert the battery pack
in the charger. The red (charging) light will blink repeatedly indicating that the charging
process has started.
3. The completion of charge will be indicated by the red light remaining ON continuously.
The battery pack is fully charged and may be used at this time or left in the charger. To
remove the battery pack from the charger, push the battery release button
battery pack.
nOtE: To ensure maximum performance and life of lithium-ion battery packs, charge the
battery pack fully before first use.
Charger Operation
Refer to the indicators below for the charge status of the battery pack.
40
into an appropriate outlet before inserting battery pack.
into the charger, making sure the battery pack is fully seated
6
7 on the