Download
Share
Print this page
Sealey Power WELDERS TIG170T Instructions Manual
  1. Manuals
  2. Brands
  3. Sealey Manuals
  4. Welding System
  5. Power WELDERS TIG170T
  6. Instructions manual

Sealey Power WELDERS TIG170T Instructions Manual

Tig/mma inverter welder 170amp 230v
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
INSTRUCTIONS FOR:
TIG/MMA INVERTER
WELDER 170Amp 230V
TIG170T
MODEL No:
Original Language Version
TIG170T
Issue: 1 - 15/11/11

Advertisement

loading

Related Manuals for Sealey Power WELDERS TIG170T

Summary of Contents for Sealey Power WELDERS TIG170T

  • Page 1 INSTRUCTIONS FOR: TIG/MMA INVERTER WELDER 170Amp 230V TIG170T MODEL No: Original Language Version TIG170T Issue: 1 - 15/11/11...

  • Page 2: Safety Instructions

    170Amp 230V MODEL No: TIG170T Thank you for purchasing a Sealey Welder. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: BEFORE USING THIS PRODUCT, PLEASE READ THE INSTRUCTIONS CAREFULLY. MAKE CAREFUL NOTE OF SAFETY INSTRUCTIONS, WARNINGS AND CAUTIONS.
  • Page 3  DO NOT touch the workpiece close to the weld as it will be very hot. Allow to cool.  DO NOT touch the torch immediately after use. Allow the torch to cool.  DO NOT operate inverter when tired or under the influence of drugs, alcohol or intoxicating medication. ...
  • Page 4 3. CONTROLS FRONT PANEL LAYOUT (refer to Figure 2). 1. OPERATING MODES AND PARAMETERS BUTTON. Primary function. MMA or TIG selection. Secondary function (press and hold in MMA mode). Hot Start, Arc Force and VRD (Voltage Reduction Device). Rapid press and release of the button allows parameter selection to be controlled by the Encoder (5) with the relative value displayed on the Alphanumeric display (3).

  • Page 5: Electromagnetic Compatibility

    TIG CONNECTIONS. “TIG” TORCH CABLE. Dinse plug at the end of the torch cable will be connected to the negative socket (-) on the front panel (see fig.2 item 6). WORK CLAMP CABLE. Dinse plug at the end of the clamp cable will be connected to the positive socket (+) on front panel (see fig.2 item 7). (*) Please note that the way the welding cables are connected to the inverter for ordinary MMA welding may be different to the way the cables are connected for standard TIG welding.
  • Page 6 MAINTENANCE OF THE WELDING EQUIPMENT. The welding equipment should be routinely maintained according to these instructions. All access and service door covers should be closed and properly fastened when the welding equipment is in operation. The welding equipment should not be modified in any way except for those changes and adjustments covered in these instructions.

  • Page 7: Maintenance

    9.1.4 In the event of any problems of unsatisfactory weld performance please first go through the trouble shooting procedure shown below. If this does not solve the problem the Inverter must be taken to a qualified and authorised service agent for repair. Contact your local Sealey dealer for service.