Sealey WBR01 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instructions gloves
1. SAFETY
9
Always distribute the load evenly over the surface of the wheelbarrow.
8
DO NOT overload the wheelbarrow.
8
DO NOT use wheelbarrow on uneven ground and DO NOT run over curbs or steps - use a ramp.
8
DO NOT allow others to ride in the wheelbarrow.
8
DO NOT use the wheelbarrow if any part is damaged, paying particular attention to the wheel.
8
DO NOT inflate the tyre to more than 25psi.
2. INTRODUCTION
Heavy duty wheelbarrow ideal for construction as well as general domestic use. Our wheelbarrows use air filled pneumatic tyres, perfect for
absorbing impact and are ideal for use on uneven surfaces and rough terrain. Constructed with strong tubular steel frame and rubber gripped
handles. Wheel Size: Ø390mm.
3. SPECIFICATION
Model No.: .................................................................WBR01
Capacity ......................................................................... 100L
Capacity (Weight) ........................................................ 120kg
4. ASSEMBLY
4.1. FRAME ASSEMBLY
4.1.1. Carefully remove plastic wrapping from the frame.
4.1.2. Carefully remove component package from cross member.
The front support arm is already engaged with the frame. This will need adjustment at the final stage of assembly.
4.1.3.
4.2. WHEEL ASSEMBLY
4.2.1. Locate plastic bearing supports into recesses in wheel hub.
4.2.2. Undo and remove one of the bolts on the end of the metal bearing shaft.
4.2.3. Locate wheel within the frame brackets and slide the bearing shaft through.
Refit bolt and tighten to ensure a secure fit of wheel assembly within the frame.
4.2.4.
4.3. PAN AND FRAME ASSEMBLY
Partially invert pan to allow internal access to the fixing holes.
4.3.1.
Pass screws from inside the pan, through the frame fixing holes, and engage plain washer, spring washer and nut pack
4.3.2.
on outside.
DO NOT tighten the fixings until all fixings are in place and engaged.
8
4.4. FRONT SUPPORT ASSEMBLY
Adjust the location of the support to enable alignment of the hole in the support to match with the fixing hole in the pan.
4.4.1.
4.4.2. Pass the screw through the pan from the inside to the outside and engage plain washer, spring washer and nut pack.
FINAL ASSEMBLY
With all fixings in place, apply final tightening to all fixings.
4.4.3.
8
DO NOT over tighten.
© Jack Sealey Limited
WHEELBARROW 100L HEAVY DUTY
WBR01
MODEL NO:
Wear safety
footwear
Original Language Version
WBR01 Issue 1 25/07/22