16 | Vocollect Talkman A700 Product Guide
Charging an A700 Device Battery
Caution: A700 device batteries and other Honeywell batteries are not interchangeable. If you try to
insert the wrong battery into a device, you may damage the device and the battery.
A700 devices use a Vocollect Charger that charges the high-performance battery while still seated in a device
and a separate charger for charging batteries that have been removed from the device.
Charging an A700 Battery in a Device
1. Remove the device from the belt clip.
2. Disconnect any wired peripherals.
3. Insert the device into an open slot on the charger, ensuring that the battery contact side of the device is
placed against the battery contact side of the slot.
4. After the device has been placed into the charger, make sure that the device state indicator on the device
turns on a solid yellow.
a) If the indicator does not turn on after 30 seconds, remove the device from the charger slot and then
place it into the slot again.
b) If the indicator still does not turn on, try another charger slot.
Caution: Do not attempt to place the device into the charger unless you have first disconnected the
headset and any other peripheral devices. Do not remove the battery from the device when placing a
device into a charger.
Charging an A700 Device Battery
Note:
•
A battery is fully charged and can be removed from the charger when the ring LED indicator light for
that port on the charger is green.
Confidential: For informational use by Honeywell resellers and customers only
Figure 2: Talkman A700 Standard and High Capacity Batteries