Specifications - Sony HMI-3000MT Instructions For Use Manual

Specifications

General
Power requirement
24 V DC (supplied from AC adaptor)
Input current 1.5 A
Operating conditions
Temperature: 5 °C to 35 °C
(41 °F to 95 °F)
Humidity: 25% to 80%
(no condensation allowed)
Pressure: 700 hPa to 1060 hPa
Storage and transport conditions
Temperature: -20 °C to +60 °C
(-4 °F to +140 °F)
Humidity: 20% to 80%
(no condensation allowed)
Pressure: 700 hPa to 1060 hPa
Dimensions (width / height / depth, excluding maximum
protrusions)
Approx. 306 mm × 56.5 mm × 358 mm
1 ⁄
(12 in. × 2
8
Mass Approx. 3.3 kg (7 lb. 4.4 oz.) (excluding
power cord)
Input/output connectors
DVI input connectors
DVI-D connectors (2)
TMDS single link
SDI input connectors
BNC type (2)
SMPTE 292M standard compliance
DC IN connector
3-pin DIN, 24 V
AC adaptor (AC-81MD etc.)
REMOTE connectors
Stereo mini jack (2)
DVI output connectors
DVI-D connectors (2)
TMDS single link
SDI output connectors
BNC type (2)
SMPTE 292M standard compliance
HMM output connector
Dedicated 20-pin (2)
(connects to HMO-CA50M)
Input/output supported signals
Video input (2D)
720/50p, 720/60p, 1080/50i, 1080/60i,
1080/50p, 1080/60p
Video input (3D)
Side-by-side, Dual stream
720/50p, 720/60p, 1080/50i, 1080/60i
1 ⁄ 1 ⁄
in. × 14 in.)
4 8
Output signal Input signal is output as-is. Note that the
following signals are not supported.
DVI signals:
• Signals with HDCP (also not output to
the HMM-3000MT)
• Signals with HDMI functions
• Signals with resolution higher than
Full HD
SDI signals:
• Audio signals
• 3G-SDI signals or higher
Supplied accessories
Before Using this Unit (1)
CD-ROM (Instructions for Use) (1)
AC adaptor (1)
Instructions for Use for AC adaptor (1)
Service Contact List (1)
Information for Customers in Europe (1)
Optional accessories
HMM-3000MT head mounted monitor
HMO-CA50M head mounted display cable
FS-24 foot switch
Caution
The FS-24 has only an IPX3 splash proof rating, and
should not be used in locations where it may be exposed
to fluids (e.g., operating rooms). For safety, products with
IPX6 or higher rating should be used in such instances.
Remote control using REMOTE connector
Sending the remote control pulse signal, illustrated below,
via the REMOTE connector performs the same
operations as pressing the INPUT button.
Timing pulse for REMOTE connector
REMOTE pin assignment
Control N.C. GND
178
35
Specifications