KitchenAid Architect Series II KFGS306V Dimensions

PRODUCT MODEL NUMBERS
KFGS306V KFGU706V
KFGS366V KFGU766V
Gas Supply: This cooktop is factory set for use
with Natural gas. Cooktop can be converted to LP
gas. Provide a gas supply line of
pipe to the cooktop location. A smaller size pipe on
longer runs may result in insufficient gas supply.
Pipe-joint compounds that resist the action of LP
gas must be used. Do not use TEFLON
LP gas, piping or tubing size can be
Usually, LP gas suppliers determine the size and
materials used in the system.
Electrical: A 120 volt, 60 Hz., AC only, 15-amp
fused, electrical circuit is required. A time-delay
fuse or circuit breaker is also recommended. It is
recommended that a separate circuit serving only
this cooktop be provided.
CABINET OPENING DIMENSIONS
C
K
J
M
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
® Gas Built-in Cooktop
OVERALL DIMENSIONS
" (1.9 cm) rigid
® tape. With
" minimum.
A
D
B
F G
E
H
L
I
³
A. 30 " (76.7 cm) on 30" (76.2 cm) models,
36 " (92.0 cm) on 36" (91.4 cm) models
B. 21" (53.3 cm)
C. 3 " (8.3 cm)
"
A. 30 (76.2 cm) on 30
"
36 (91.4 cm) models
B. Combustible area above countertop (shown by dashed box above)
"
C. 30 (76.2 cm) minimum clearance between top of cooktop platform
and bottom of unprotected wood or metal cabinet (24
minimum clearance if bottom of wood or metal cabinet is protected by
"
not less than
less than No. 28 MSG sheet steel, 0.015
"
0.024 [0.06 cm] aluminum or 0.020
range hood see NOTES.*
"
D. 13 (33.0 cm) recommended upper cabinet depth
"
E. 1 (2.8 cm)
"
F. 20 (50.8 cm)
G. 18" (45.7 cm) minimum clearance from upper cabinet to countertop
within minimum horizontal clearances to cooktop
H. Grounded outlet - Locate within 24" (61.0 cm) of right rear corner of
cutout
N
I. 29" (73.7 cm) on 30" (76.2 cm) models; 35¼" (89.5 cm) on
36" (91.4 cm) models
J. 24" (61.0 cm) minimum countertop depth is required
K. 2 " (7.3 cm) minimum distance to rear combustible surface
L. Gas line opening - Wall: anywhere 5" (12.7 cm) below underside of
countertop. Cabinet floor: anywhere within 6" (15.2 cm) of rear wall is
recommended
M. 8" (20.3 cm) minimum distance to nearest left side combustible
surface.**
N. 8" (20.3 cm) minimum distance to nearest right side combustible
surface.**
30" (76.2 cm) Cooktop Overall: M + N must equal 48" (122.0 cm)
minimum + 29" (73.7 cm) cutout for cooktop or 77" (195.6 cm)
36" (91.4 cm) Cooktop Overall: M + N must equal 48" (122.0 cm)
minimum + 35¼" (89.5 cm) cutout for cooktop or 83¼" (211.5 cm)
**M + N combined must be at least 48" (122.0 cm) minimum overall
Example 1: M = 8" (20.3 cm) left side + N = 40" (101.6 cm) right side
= 48" (122.0 cm)
Example 2: M = 24" (61.0 cm) left side + N = 24" (61.0 cm) right side
= 48" (122.0 cm)
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
A
B
" "
(76.2 cm) models; 36 (91.4 cm) on
[0.6 cm] flame retardant millboard covered with not
"
[0.04 cm] stainless steel, or
"
[0.05 cm] copper). If installing a
C
"
[61.0 cm]
Ref. 8286867
03-25-08