Related Manuals for Siemens WM10K160HK
Summary of Contents for Siemens WM10K160HK
- Page 1 Washing machine WM10K160HK WM12K160HK siemens-home.com/welcome Register your product online ens-home.com/welcome...
- Page 2 Your new washing machine Display rules : Warning! You have chosen a Siemens washing machine. This combination of symbol and signal word indicates a possibly dangerous Please take a few minutes to read and situation. Not heeding the warning can become familiar with the advantages of cause death or injuries.
-
Page 3: Table Of Contents
Contents e n I n s t r u c t i o n M a n u a l a n d I n s t a l l a t i o n I n s t r u c t i o n s Intended use. -
Page 4: Intended Use
Intended use Cleaning and maintenance . . . 23 Intended use Machine housing/control panel ..23 Drum ......23 For private domestic use only. -
Page 5: Safety Instructions
Safety instructions If you lean on the washing Safety instructions ■ machine door when it is open, the washing machine Electrical safety may tip over and cause S a f e t y i n s t r u c t i o n s injuries. - Page 6 Safety instructions Warning Warning Danger of death! Risk of poisoning! Children may lock themselves Detergents and care products in appliances, putting their lives may be poisonous if at risk. consumed. For appliances that have Keep detergents and care reached the end of their service products out of the reach of life: children.
-
Page 7: Environmental Protection
Environmental protection Tips on economical use Environmental protection Always fill the appliance with the ■ maximum amount of laundry for the relevant programme. Packaging/used appliance Overview of programmes E n v i r o n m e n t a l p r o t e c t i o n ~ Page 13 Dispose of packaging in an Wash normally soiled laundry... -
Page 8: Main Points In Brief
Main points in brief Main points in brief M a i n p o i n t s i n b r i e f Connect the mains Turn on the water Sort the laundry. Open the door. plug. tap. -------- Select a programme Observe the... -
Page 9: Getting To Know The Appliance
Getting to know the appliance Getting to know the appliance Washing machine G e t t i n g t o k n o w t h e a p p l i a n c e Detergent drawer ~ Page 18 Controls/display elements Washing machine door with window handle... -
Page 10: Control Panel
Getting to know the appliance Control panel 8 Start/Reload ! for starting, ( 0 (Spin speed), 5 (Ready in) for interrupting (f.e. adding/removing changing the programme default laundry) and cancelling a settings programme Overview of all programme default @ Programme selector for selecting settings ~ Page 15 a programme and for switching 0 speedPerfect G, Water Plus 0... -
Page 11: Laundry
Laundry Sorting laundry Laundry Sort your laundry according to the care P repare the laundry instructions and manufacturer's L a u n d r y information on the care labels: Caution! Type of fabric/fibre ■ Damage to the appliance/fabrics Colour ■... -
Page 12: Detergent
Detergent Saving energy and detergent Detergent For light and normal soiling, you can C orrect selection of detergent save energy (lower washing D e t e r g e n t temperature) and detergent. The care label is crucial for selecting the correct detergent, temperature and Saving Soiling/note... -
Page 13: Overview Of Programmes
Overview of programmes Overview of programmes Programmes on the programme selector O v e r v i e w o f p r o g r a m m e s Programme/type of laundry/information Settings/Presettings of the pro- grammes are highlighted in bold Max. - Page 14 Overview of programmes Programme/type of laundry/information Settings/Presettings of the pro- grammes are highlighted in bold Max. 2 kg/3.5 kg G Super Quick 15’/30’ Extra-short programme of approx. 15 minutes, suitable for small cold items of lightly soiled laundry – – – ... 800 ... 1200** rpm Note: Longer programme duration (approx.
-
Page 15: Starching
Programme default settings Programme/type of laundry/information Settings/Presettings of the pro- grammes are highlighted in bold 0 Spin/Drain p Extra spin with speed that can be selected If only the drain cycle is required, set the spin speed to – – –. –... -
Page 16: (Ready In) 5
Additional programme settings (Ready in) 5 Adding laundry while the preselected time continues running: (“Ready in” time) Press Start/Reload ! . The symbols YES and v light up on When you select the programme, the the display panel. The washing relevant programme duration is machine door can be opened and displayed. -
Page 17: Operating The Appliance
Operating the appliance Change the programme Operating the default settings appliance You can use the default settings or Preparing the washing change them. O p e r a t i n g t h e a p p l i a n c e machine To do this, repeatedly select the corresponding button until the required... -
Page 18: Measure And Add Detergent And Care Products
Operating the appliance Notes Measuring Mix items of laundry of varying sizes. ■ Measure the detergent and care Laundry items of different sizes products according to: distribute themselves better during the spin cycle. Individual items of Water hardness; ask your water ■... -
Page 19: Starting The Programme
Operating the appliance Pull out the detergent drawer as far If you want to lock the Note: as possible. programme to prevent it from being Add detergent and/or care products. inadvertently adjusted, you can select Close the detergent drawer. the childproof lock as follows. Measuring aid* for liquid detergent Childproof lock *depending on the model... -
Page 20: Changing The Programme
Operating the appliance Do not leave the washing Programme end during rinse Note: machine door open for too long when hold adding laundry as water from the laundry may leak out. – – – 0 appears on the display panel and the Start/Reload ! button indicator If the display panel shows: lamp flashes. -
Page 21: Sensors
Sensors VoltMonitor The automatic voltage control system detects unauthorised voltage drops during the washing process. Whenever there is an Note: undervoltage, the colon flashes on the Leave the washing machine door ■ Ready in display on the display panel. and detergent drawer open so that any residual water can dry away. -
Page 22: Setting The Signal
Setting the signal Setting the signal S e t t i n g t h e s i g n a l 1. Activate the setting mode for the signal volume Set to Ú. Press and hold the 0 button and turn one Press and hold the button for position to the right. -
Page 23: Cleaning And Maintenance
Cleaning and maintenance Descaling Cleaning and Descaling should not be necessary if maintenance the detergent is measured out correctly. However, if it is required, follow the Warning manufacturer's instructions for the C l e a n i n g a n d m a i n t e n a n c e Danger of death! descaling agent. -
Page 24: Detergent Solution Pump Blocked
Cleaning and maintenance Detergent solution pump Carefully unscrew the pump cover, residual water may leak out. blocked Clean the interior, pump cover thread and pump housing. The Warning impeller in the detergent solution Risk of scalding! pump must be able to rotate. When you wash at high temperatures, Refit the pump cover and screw it on the water gets very hot. -
Page 25: The Drain Hose At The Siphon Is Blocked
Cleaning and maintenance The drain hose at the siphon Clean the filter on the water tap: Remove the hose from the water tap. is blocked Clean the filter with a small brush. Switch off the appliance. Disconnect the mains plug. Loosen the hose clamp. -
Page 26: Faults And What To Do
Faults and what to do about them Caution! Faults and what to do Water damage about them Any escaping water may cause water damage. Do not open the washing Emergency release machine door if water can be seen F a u l t s a n d w h a t t o d o a b o u t t h e m through the glass. -
Page 27: Information On The Display Panel
Faults and what to do about them Information on the display panel Display Cause/remedial action The washing machine door is unlocked. It is possible to add laundry. The temperature is too high. Wait until the temperature falls. ■ Water level too high. Not possible to add laundry. If necessary, close the wash- ■... -
Page 28: Faults And What To Do About Them
Faults and what to do about them Faults and what to do about them. Faults Cause/remedial action Water is leaking out. Attach/replace the drainage hose correctly. ■ Tighten the screw connection of the supply hose. ■ No water supply. Start/Reload ! not pressed? ■... - Page 29 Faults and what to do about them Faults Cause/remedial action The symbol x flashes Too much detergent used? ■ in the display panel. Foam Mix one tablespoon of fabric softener with 1/2 litre water and pour into may escape from the compartment II (not for outdoor fabrics, sportswear fabrics or those made detergent drawer.
-
Page 30: After-Sales Service
After-sales service After-sales service If you cannot correct the fault yourself A f t e r - s a l e s s e r v i c e ~ "Faults and what to do about them" on page 26 please contact our after- sales service. -
Page 31: Consumption Rates
Consumption rates Consumption rates Consumption values table C o n s u m p t i o n r a t e s Programme Load Energy consumption* Water* Programme du- ration* Cottons Î cold 7 kg 0.21 kWh 68 l Cottons Î... -
Page 32: Technical Data
Technical data Technical data Dimensions: T e c h n i c a l d a t a 850 x 600 x 590 mm (Height x width x depth) Weight 63-83 kg (depending on model) Mains connection: Mains voltage 220-240 V, 50 Hz Nominal current 10 A Nominal input 2300 W Water pressure:... -
Page 33: Positioning And Connecting
Positioning and connecting ( Mains cable Positioning and 0 Bag: connecting Installation and operating ■ instructions Included with the appliance After-sales service location ■ P o s i t i o n i n g a n d c o n n e c t i n g directory* Check the machine for transport Note:... -
Page 34: Installation Surface
Positioning and connecting If the hose and mains cables are not The feet of the appliance must be ■ routed properly, there is a risk of secured with holding brackets. tripping and injury. Order no. WMZ 20490, Lay hoses and cables in such a way WZ 20490 WZ 20510, WZ 20520 that there is no risk of tripping. -
Page 35: Hose And Cable Lengths
Positioning and connecting Keep the screws and sleeves in Hose and cable lengths Note: a safe place. Left-hand connection ■ Take the hoses out of the holders. Right-hand connection ■ Unscrew and remove all four transport brace screws. Remove the sleeves. To do this, remove the mains cable from the holders. -
Page 36: Water Inlet
Positioning and connecting Water inlet Warning Risk of death! There is a risk of electric shock if you touch live components. Observe the following when connecting – Model: AquaSecure the machine: Notes Only operate the washing machine ■ using cold mains water. Do not connect the machine to the ■... -
Page 37: Levelling
Positioning and connecting Levelling Caution! Damage to the appliance/fabrics Level the appliance using a spirit level. If the end of the drain hose is immersed in the drained water, water Incorrect levelling may result in intense may be sucked back into the noise, vibrations and "wandering". -
Page 38: Before Washing For The First Time
Positioning and connecting ordinances. To ground the appliance Notes use a 3 pin plug and properly grounded The mains voltage and voltage ■ socket of 16 A rating. indicated on the washing machine (rating plate) are the same. Notes The connected load and fuse Do not modify the plug provided with required are specified on the rating ■... -
Page 39: Transportation
Positioning and connecting Pour approx. 1 litre of water into Installing the transport locks: compartment II. Remove the covers and keep them Pour standard detergent into in a safe place. compartment II. Use a screwdriver if necessary. To prevent foaming, only use Note: half of the amount of detergent recommended by the detergent... - Page 40 01450 2655 (0.03 € per minute at peak. Off peak 0.0088 € per minute.) You can find the contact information for all countries in the attached after-sales service directory. BSH Hausgeräte GmbH Carl-Wery-Straße 34 81739 München GERMANY siemens-home.com *9001158320* 9001158320 (9510)