Table of Contents
Advertisement
TROUBLESHOOTING
Problem
ODOR Indicator
● After the operation starts, ODOR Indicator Light does not change its
Light does not
color for the time being due to unsteady sensitivity of the sensor.
After a few minutes, sensitivity of the sensor becomes steady.
change its color
● If ODOR Indicator Light remains green, the air is fresh.
It is hard for the sensor to detect in some places. It is normal if
ODOR Indicator Light changes its color when cigarette smoke is
blown to the sensor.
● If the operation is started in a room with a strong odor, sensitivity of
the odor sensor may become blunt.
Please continue the air purifying operation (MED) for several
hours or 1 day.
● Dust may accumulate on the sensor.
Please remove the rear panel and
the filters and clean them with
a cleaner through the hole as
shown in the right figure.
ODOR Indicator Light
● It may not turn green due to dirt comes from outdoors when the window
does not turn green
or the door is opened frequently or the room is of poor airtightness.
ODOR Indicator Light
● It may respond to wind and temperature change caused by opening
often switches
and closing of the door frequently.
The AIR PURIFYING
● The AIR PURIFYING indicator light cannot be turned off during
indicator light does
operation.
not turn off
In all operation modes, air is purified through the HEPA filter and the
Active Carbon Deodorizing filter.
The float comes off
● Install the float by following the procedure below.
1 Check the direction of float, and then
insert the float.
(
Magnet: Facing up
Facing outside of tank
E - 30
(Continued)
Solution
Reference
(Back of the main unit)
Sensor
(inside)
2 Insert pin and
secure.
(
Pin
Magnet
Float
Problem
Page
The unit cannot operate
—
Buttons do not work
—
The operation stops
E - 17
Beep
Beep_
E - 25
Blinking (red)
Long beep
—
Blinking
(green)
—
Long beep
—
Blinking
(green)
Blinking
(green)
Other indicator
lights blinking
The main unit falls down
(during dehumidifying or
laundry drying operation
or while water enters the
tank)
Solution
● Check the CHILD LOCK setting.
If locked, release the child lock.
● Check the power plug.
If not inserted, insert the power plug into an outlet.
● Check to see if there is a power outage.
If there is a power outage, wait until the power is resumed.
● Check to see if the water tank is properly placed.
If not, place the water tank correctly.
● Check to see if the water tank is full.
If the tank is full, drain the water.
● Check to see if the float is properly placed.
If not, place the float properly.
● The operation has stopped with the Auto Off function.
Press the OFF button to stop the indicator light from blinking,
and start the operation again.
When using continuously, disable the Auto Off function.
● The water tank becomes full and the operation has stopped with the
Auto Off function.
Empty the water tank, press the OFF button to stop the
Blinking
indicator light from blinking, and start the operation again.
(red)
● Laundry drying (Auto) operation has completed, and the operation
has stopped.
Long beep
Press the OFF button to stop the indicator light from blinking, and
start the operation again.
● The unit may malfunction.
Please consult the store where you purchased the product or
SHARP authorized service center.
● When the main unit falls down while water enters the tank, pull out
the power plug and consult the store where you purchased the
product or SHARP authorized service center.
Reference
Page
E - 19
—
—
E - 20
E - 20
E - 30
E - 11
E - 11,20
E - 14
—
—
E - 31
Advertisement
Table of Contents
