14. ENVIRONMENTAL CONCERNS..............28 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
The operating water pressure (minimum and • maximum) must be between 0.5 (0.05) / 10 (1.0) bar (MPa) Follow the maximum number of 14 place settings. • If the supply cord is damaged, it must be replaced by •...
Page 5
ENGLISH 2.4 Use • Make sure not to cause damage to the mains plug and to the mains • Do not put flammable products or cable. Should the mains cable need to items that are wet with flammable be replaced, this must be carried out products in, near or on the appliance.
ENGLISH 3.1 TimeBeam When AirDry is activated during the drying phase, the TimeBeam displays the following projection on the floor may information on the floor below the not be completely visible. To appliance door: check the remaining time of • The programme duration when the the running programme, look programme begins.
5. PROGRAMMES The numbering of the programmes in the The order of the programmes in the table table (P1, P2, etc.) reflects their may not reflect their sequence on the sequence on the control panel. control panel. Programme Degree of soil Programme pha‐...
Page 9
ENGLISH Programme Degree of soil Programme pha‐ Options Dishwasher load No load • Self-cleaning Machine Care 1) This programme offers the most efficient use of water and energy consumption for crock‐ ery and cutlery with normal soil. This is the standard programme for test institutes. This pro‐ gramme is used to assess compliance with the Ecodesign Comission Regulation (EU) 2019/2022.
Water Energy Duration Programme (kWh) (min) 11.8 0.98 GlassCare 0.01 Rinse Hold 10.6 0.71 Machine Care 1) The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of dishes and the degree of soil can change the values.
Page 11
ENGLISH 6.2 The water softener The water softener should be adjusted according to the hardness of the water in The water softener removes minerals your area. Your local water authority can from the water supply, which would have advise you on the hardness of the water a negative effect on the washing results in your area.
Page 12
In case of the high water softener setting, • The display shows the current it may occur also in the middle of the setting: e.g. = level 5. programme, before the rinse (twice 2. Press repeatedly to change the during a programme).
Page 13
ENGLISH 6.6 How to set the colour of the Factory setting: level 4. TimeBeam How to set the rinse aid level Make sure the appliance is in user mode. Make sure the appliance is in user mode. It is possible to change the colour of the TimeBeam to match the colour of the 1.
AirDry is automatically activated with all 2. Press to change the setting. programmes excluding Rinse Hold (if 3. Press on/off to confirm the setting. applicable). 6.8 MyFavourite The duration of the drying phase and the door opening time vary depending on the This option allows to set and save the selected programme and options.
ENGLISH This configuration can be changed at any washing and the drying phases are time. shorter. By default, TimeManager is off, but it is Every time Eco is activated, possible to activate it manually. This XtraDry is off and needs to option cannot be combined with XtraDry.
Page 16
CAUTION! The compartment (B) is for rinse aid only. Do not fill it with detergent. CAUTION! Only use rinse aid designed specifically for dishwashers. 1. Open the lid (C). 2. Fill the dispenser (B) until the rinse 4. Carefully shake the funnel by its aid reaches the marking ''MAX''.
ENGLISH 9. DAILY USE 1. Open the water tap. The basket is automatically locked on the 2. Press the on/off button to activate the upper level. appliance. 2. Carefully place items in the basket or Make sure that the appliance is in remove them (refer to the basket programme selection mode.
Page 18
1. Press the release button (A) to open Starting a programme with the lid (C). delay start 2. Put the detergent (gel, powder or tablets) in the compartment (B). 1. Set a programme. 3. If the programme has a prewash 2.
ENGLISH Make sure that there is detergent in the appliance is automatically detergent dispenser before you start a deactivated. new programme. 2. Close the water tap. End of the programme The Auto Off function When the programme is complete, the This function decreases energy display shows 0:00.
Page 20
This can results and hard-water filming or cause them to crack, warp, discolour, spotting on the items. Using too much pit or rust. detergent with soft or softened water • Do not wash in the appliance items...
ENGLISH 11. CARE AND CLEANING WARNING! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. Dirty filters and clogged spray arms decrease the washing results. Make a 4. Wash the filters. check regularly and, if necessary, clean them.
Page 22
CAUTION! 4. To install the spray arm back, press An incorrect position of the the spray arm upwards and filters can cause bad simultaneously turn it washing results and damage counterclockwise until it locks into to the appliance. place.
ENGLISH • Use the automatic cleaning toothpicks, etc) decrease the cleaning programme for optimal cleaning performance and can cause damage to results. the drain pump. • Using short-duration programmes CAUTION! regularly can cause grease and If unable to remove the limescale buildup inside the foreign objects, contact an appliance.
Page 24
Problem and alarm code Possible cause and solution The appliance does not • Make sure that the sink spigot is not clogged. drain the water. • Make sure that the interior filter system is not clog‐ The display shows i20.
Page 25
ENGLISH Problem and alarm code Possible cause and solution The remaining time in the • This is not a defect. The appliance is working cor‐ display increases and rectly. skips nearly to the end of the programme duration. Small leak from the appli‐ •...
Page 26
12.1 The dishwashing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and the basket loading leaflet. • Use more intensive washing programmes. • Clean spray arm jets and the filter. Refer to "Care and Cleaning".
ENGLISH Problem Possible cause and solution There are residues of deter‐ • The detergent tablet got stuck in the dispenser and gent in the dispenser at the was not washed away by water. end of the programme. • Water cannot wash away the detergent from the dispenser.
Capacity Place settings 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy (e.g. solar panels), use the hot water supply to decrease energy consumption. 13.1 Link to the EU EPREL EPREL database using the link https:// eprel.ec.europa.eu and the model name...