Setting The User Bit - Canon XA60 Instruction Manual

Setting the User Bit

Setting the User Bit
The user bit display can be selected from the date or the time of recording, or an identification code
consisting of 8 characters in the hexadecimal system. There are sixteen possible characters: the
numbers 0 to 9 and the letters A to F. The user bit will be output from the SDI OUT terminal (
only) and HDMI OUT terminal. The user bit is recorded with XF-AVC clips.
Operating modes:
70
1 Open the [User Bit Settings] screen.
> [3 # Recording Setup]
• To set the time for the user bit, select [
[ Date]. Then, select [
• The user bit setting screen will appear with the orange selection frame on the leftmost digit.
• To reset the user bit to [00 00 00 00], select [Reset].
• Select [Cancel] to close the screen without setting the user bit.
2 Select the digit you want to change and then select [
3 Select another digit you want to change.
4 Change the rest of the digits in the same way.
5 Select [OK] and then select [X].
NOTES
• The user bit will not be recorded with MP4 clips that are recorded to an SD card.
>
[User Bit Type]
Time] instead; to set the date for the user bit, select
X
]. The rest of the procedure is not necessary.
>
[i]
Í] or [Î ] to change it as necessary.