Components And Functions; Laser Safety Statements; Transfer To Third Party - NEC N8151-138 User Manual

Cautions on Installation, Movement, Storage, and Connection
Do not install this product in any place other than specified.
Do not install this product in the following places or any place other than specified in this User's Guide. Failure to
follow this instruction may cause a fire.
● a dusty place
● a place exposed to direct sunlight
Do not use any unauthorized interface cable.
Use only interface cables provided by NEC and locate a proper device and connector before connecting a cable.
Using an authorized cable or connecting a cable to an improper destination may cause a short circuit, resulting in a
fire.
● Do not step on the cable.
● Do not use the server with loose cable connections.
● Securely fasten connectors with supplied screws, if any.
Do not use the equipment in the place where corrosive gases exist.
Make sure not to locate or use this product in the place where corrosive gases (sulfur dioxide, hydrogen sulfide,
nitrogen dioxide, chlorine, ammonia, ozone, etc) exist. Also, do not set it in the environment where the air (or dust)
includes components accelerating corrosion (ex. sulfur, sodium chloride) or conductive metals. There is a risk of a fire
due to corrosion and shorts of an internal printed board.
Make sure to complete device installation.
Always install this product firmly. An incompletely installed device may cause a contact failure, resulting in smoking or
fire.
To install this option product to your server, read, understand and confirm the instruction (including CAUTION) in the User's Guide of the server
prior to installation.

Laser Safety Statements

This product is classified as a CLASS 1 LASER PRODUCT and conforms to IEC 60825-1 and EN60825-1.
Trademarks
Microsoft® and W indows® are registered trademarks or trademarks of Microsoft Corporation in the United States and other countries.
All other product, brand, or trade names used in this publication are the trademarks or registered trademarks of their respective trademark owners.

Transfer to Third Party

To transfer or sell the product or the accessories that come with the product to a third party, make sure to provide this User's Guide together with
the product or the accessories to a third party.
1. Components
Check if the packing box contains all the items listed below.
No. Product name
Internal DVD-SuperMulti Drive
1
SATA Cable
2
SATA Y Cable
3
SATA dual Cable
4
Screw
5
Writing Software
6
7 User's Guide
CAUTION
● a humid place such as near a boiler
● an unstable place
● Do not place any object on the cable.
● Do not use any damaged cable / connector.
Qty Remarks
Drive bracket accessory
1
1
1
1
1
1
1 This manual
- 11 -

2. Components and Functions

< Front View >
1 2 3
1 Tray
Place on which a disc is put
2 Access lamp
The access lamp operates as shown in the table below under the power-on status
Operation status Indication
Writing Lit or Blinking
Reading Lit or Blinking
3 Eject button
Press this button to eject a disc into or from the product. (The button does not operate if the power of the product is OFF or the
relevant program prohibits it from operating.)
4 Emergency hole
Insert a pin (such as a clip extended straight) into this hole to eject the tray manually. (The hole is provided to eject the tray manually
when the eject button and the relevant software are not available for the ejection.)
< Rear View >
1 2
1 Drive bracket
2 SATA power connector
3 SATA interface connector
・SATA Cable
1
1 SATA connector
4
3
- 12 -