Table of Contents
Advertisement
Operation
Charging the Battery Pack
Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1.
Ensure that the vents on the battery and charger
are clear of any dust and debris.
1. Battery pack cavity
2. Battery pack venting areas 6. Handle
3. Battery pack terminals
4. LED indicators (current
charge)
2.
Line up the cavity on the battery pack with a
tongue on the charger
3.
Slide the battery pack into the charger until it is
fully seated
(Figure
7).
Figure 5
5. Battery-charge-indicator
button
7. Charger
(Figure
5).
5).
4.
If you are charging multiple battery packs,
you can switch between 2 charging modes
by pressing the A/B button on the side of the
charger:
•
Serial charging (Mode A): Fully charges 1
battery pack at a time; once fully charged,
the next battery starts charging. This results
in individual fully-charged batteries, faster.
•
Parallel charging (Mode B): All connected
battery packs are charged to the same level.
This results in all connected batteries being
evenly charged.
Note:
A battery connected to the charger may
not always be charging; if the indicator light on
the charger is yellow, that battery is on standby.
Other batteries may have priority (they are
charged first due to their state of charge or the
charging mode selected); once other batteries
have charged to the necessary level, the battery
on standby begins to charge.
5.
To remove the battery pack, slide the battery
backward out of the charger.
6.
Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator
Indicates
light
Off
No battery pack inserted
Yellow
Battery pack is on standby while other battery
pack(s) are charging
Green
Battery pack is charging
blinking
Green
Battery pack is charged
Red
Battery pack and/or battery charger is over or under
the appropriate temperature range
Red
Battery pack charging fault*
blinking
g365020
*Refer to
Troubleshooting (page 10)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
8
for more
9).
Advertisement
Table of Contents
