LG LW1000ER Owner's Manual page 7

Remote Control Operations Remote Control Operations
1
POWER
Operation starts when this button is pressed and
stops when you press the button again.
2
TEMPERATURE CONTROL
The thermostat monitors room temperature to
maintain the desired temperature.
The thermostat can be set between 60°F~86°F
(16°C~30°C).
The unit takes an average of 30 minutes to adjust
the room temperature by 1°F.
3
OPERATION MODE SELECTOR
Select cooling mode to cool the room.
Select energy saver mode for energy saving
operation.
Select fan mode for basic ventilating fan
operation.
Select dry mode for dry operation.
4
FAN SPEED SELECTOR
For increased power while cooling, select a
higher fan speed.
3 steps: High Low
5
ON/OFF TIMER
The timer can be set to start and stop the unit in
hourly increments (up to 12 hours).
6
REMOTE CONTROL SENSOR
Inserting the Remote Control Batteries
1
Push out the cover on the back of the remote control with your thumb
2
Pay attention to polarity and insert two new AAA 1.5V batteries.
3
Reattach the cover.
NOTE: Do not use rechargeable batteries. Make sure that both batteries are new.
• In order to prevent discharge, remove the batteries from the remote control if the
air conditioner is not going to be used for an extended period of time
Keep the remote control away from extremely hot or humid places.
To maintain optimal operation of the remote control, the remote sensor should
not be exposed to direct sunlight.
• The remote control can be mounted on a wall using the mountable holder.
Med
7
AIR PURIFIER
• Press the Air Purifier button. Operation will start
when the button is pressed and stop when the
button is pressed again.
• Set the fan speed again with the remote control.
You can select the fan speed in three
steps-high, low or medium.
Each time the button is pressed, the fan speed
mode is shifted.
• If you press the only Air Purifier button, only air
purifying operates without cooling.
Then, fan speed is low.
You can select the fan speed in three steps;
high, low, or medium.
Each time the fan speed button is pressed, the
fan speed mode is shifted.
8
SLEEP MODE
• Press the sleep mode button to set the time you
want the unit to turn off automatically.
• Every time you push this button, the remaining
time will be set as follows. (1Hour
3Hours 4Hours
7Hours 0Hours
7
2Hours
5Hours 6Hours
1Hour 2Hours ...)