Ignition System; Ignition Coil - Yamaha WaveRunner FZR-GX1800 Service Manual

– +
ELEC
Electrical analysis / Ignition system
È
V
1
É
DC V
TIP
• Before measuring the peak voltage, check all
wiring for proper connection and corrosion,
and check that the battery is fully charged.
• Use the peak voltage adapter with the rec-
ommended digital circuit tester.
• Connect the positive pin of the peak voltage
adapter to the positive terminal of the digital
2
tester, and the negative pin to the negative
terminal.
• When measuring the peak voltage, set the
selector on the digital circuit tester to the DC
voltage mode.
3
4
È For USA and Canada
É For worldwide

Ignition system

Ignition coil

1. Check:
Checking steps:
1. Connect a computer to the watercraft and
1
2. Remove the ignition coil for the cylinder
3. Connect the ignition coil to the special ser-
7-10
Digital multimeter 1:
YU-34899-A
Peak voltage adapter 2:
YU-39991
Digital circuit tester 3:
90890-03174
Peak voltage adapter B 4:
90890-03172
• Ignition spark
No spark → Measure the ignition coil
input voltage.
use the YDIS.
that will be tested.
vice tool 1.
Spark checker:
YM-34487
Ignition tester:
90890-06754
E
1
2
3
4
5
6
7
8
9