THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
1
• All resistors are in Ω and
/
W or less unless otherwise
4
specified.
•
f
: internal component.
• C : panel designation.
Note:
The components identified by mark 0 or dotted line with
mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
no mark :FM
(
) :CD STOP
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: TUNER
d
: PB (DECK A)
d
: PB (DECK B)
G
: REC (DECK B)
J
: CD
f
: AUDIO
• Waveforms
– PANEL BOARD –
1
IC601 qd (I-XT2)
5.2 Vp-p
30.5 s
2 V/DIV, 10 s/DIV
2
IC601 qh (CF2)
4.9 Vp-p
100 ns
2 V/DIV, 40 ns/DIV
HCD-RG100
SECTION 7
DIAGRAMS
Note on Printed Wiring Boards:
• X : parts extracted from the component side.
•
: Pattern from the side which enables seeing.
• Indication of transistor.
C
Q
These are omitted.
B
E
Q
B
C E
These are omitted.
• Circuit Boards Location
SW board
MOTOR (LD) board
CONNECT board
TRANS board
SUB-TRANS board
REM board
PANEL board
1 STREAM LED board
GAME JACK board
25
25
SENSOR board
BD80A board
MOTOR (TB) board
DRIVER board
AMP board
VIDEO OUT board
MAIN board
TRANSLATION board
H/P JACK board
HCD-RG100