Grounding; Power Supply And Wiring - ABB CP410M Installation And Operation Manual

Product Specifications
3.4

Grounding

To make sure that the operator terminal works properly and to prevent it from
radiating radio frequency noise, it must be connected to the earth ground.
3.5

Power Supply and Wiring

CP410 must use the power supply with 24 V DC and the power consumption
is 8 W.
Warning:
To avoid an electrical shock, be sure to switch off the power before connecting the
communication/download cable to the operator terminal.
Perform the following steps to wire the power connector:
1. Unplug the power connector and unscrew the screws.
2. Strip approximately 7-8 mm of insulation. Insert the wire all the way into
the power connector and then turn the screws tight.
3. Plug in the connector to the power input of the operator terminal.
Note:
The power connector is already plugged into the power input of operator terminal
when the package is first opened.
Use copper conductors only, 60/75
Type
Solid
Stranded
-
FG
DC 24V
12
Wire Gauge Stripped
(AWG) Length
28-12 7-8 mm
30-12 7-8 mm
°
C.
Torque
4.5 lb-in
4.5 lb-in
ABB, 1SBC159101M0202