Advertisement
The back of the refrigerator, and on the floor
Turn the adjustable legs, let it rise above the floor, then move the refrigerator.
Wipe the dirt off the back of the unit, the wall, and the floor.
Dust can collect at the back side of the unit and on the floor because of
the convection air flow, and it's an area that can easily get sooty dirt.
Check to make sure there's no water leaking on the floor.
WARNING
Do not put your hands or feet under the refrigerator.
Doing so may cause injury.
After cleaning accessories, inspect at regular intervals
Inspect your electrical plug and cord
Unplug the electrical plug from the outlet and inspect.
Is there any damage or abnormal heat coming from the plug or cord?
Wipe away dust from the plug and around the plug area with a dry cloth.
Insert the electrical plug fully into the outlet.
WARNING
If dust collects on the electrical plug or cord,
it can get damaged and can cause a fire.
How to Replace the LED Light
In the event that the LED light is damaged or malfunctions, please refrain from adjusting
or repairing it by yourself. Please contact the service center instead.
6. What to do in these situations
When there's a power failure.
Minimize opening/closing of doors and avoid putting in more food.
When not in use for a long time.
Clean the Ice tray, clean the interior after unplugging the refrigerator,
and keep the door open for 2 - 3 days to let it get dry.
If not allowed to dry properly, mold and odors can occur,
or refrigerant (gas) may leak due to corrosion of the cooling unit.
When transporting.
1. Discard water from the Drain pan/ice from the Ice tray.
2. Use protective gear (protective gloves).
3. With more than 2 persons, calmly and slowly transport the unit
by grasping the front side's lower section legs and the back side's
upper section outer shell.
Do not lay or load on its side (it will cause damage to the compressor.)
WARNING
Do not damage the refrigerant circuit, do not drive in screws, etc.
The unit uses a flammable refrigerant, so if the gas leaks out, there is the risk of ignition or an explosion.
Change
Page 4
Front side - lower
section lags
9
Soot
and
dust
Dust
Maintain
Back side - upper
section outer shell
Advertisement
