Craftsman 21AB40M1099 Operator's Manual page 12

208cc engine rear tine tiller
Table of Contents

Advertisement

Available languages

Available languages

gaS anD oil fill-UP
oil
(one bottle shipped with unit)
First Time Use
1.
Remove oil fill dipstick.
2.
With the tiller on level ground, use a funnel to empty entire
contents of oil bottle provided into the engine.
3.
Replace oil fill dipstick and tighten.
Subsequent Uses
Only use high quality detergent oil rated with API service classifica-
tion SF, or SG. Select the oil's SAE viscosity grade according to the
expected operating temperature. Follow the chart below.
1
20w40, 20w50
15w40, 15w50
2
10w40
10w30
(ºC)
-30º -20º
(ºF)
-20º
ambient temperature
1.
Single Viscosity
2.
Multi Viscosity
Although multi-viscosity oils (5W30, 10W30, etc.) improve starting
in cold weather, they will result in increased oil consumption when
used above 32°F. Check your engine oil level more frequently to avoid
possible engine damage from running low on oil.
1.
Check the oil level making certain not to rub the dipstick along
the inside walls of the oil fill tube. This would result in a false
dipstick reading. Wipe dipstick clean with cloth. Replace dipstick
into the oil filler neck, but do not screw it in. Remove and check
oil level. Refill to FULL mark on dipstick, if necessary. Capacity is
approximately 20 oz. Overfilling will cause the engine to smoke
profusely and will result in poor engine performance.
2.
Replace oil fill dipstick and tighten.
3.
Keep oil level at FULL. Running the engine with too little oil can
result in permanent engine damage.
Transmission/gear oil
First Time Use
1.
With the tiller on level ground, pull the Depth Regulator Lever
back and then all the way up until the lowest notch in the lever is
engaged. See Figure 6.
2.
Remove the oil fill plug from the transmission housing cover and
locate the main drive shaft situated inside the housing.
See Figure 7.
3.
The gear oil level is correct if the gear oil is approximately halfway
up the side of the main drive shaft.
4.
If the oil level is low, refer to the transmission gear oil under the
Maintenance Section.
OPERATION
10w
20w
20
30
40
-10º 0º
10º
20º 30º 40º
20º
40º
60º 80º
100º
Depth regulator lever
Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel machine indoors
or while the engine is hot or running. Extinguish cigarettes, cigars,
pipes, and other sources of ignition.
gasoline
1.
Remove fuel cap from the fuel tank.
2.
Make sure the container from which you will pour the gasoline is
clean and free from rust or foreign particles. Never use gasoline
that may be stale from long periods of storage in its container.
Gasoline that has been sitting for any period longer than four
weeks should be considered stale.
3.
Fill fuel tank with clean, fresh, unleaded regular gasoline only. Do
not use gasoline containing METHANOL. Replace fuel cap.
12
Figure 6
Figure 7
Warning

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

247.29930

Table of Contents