Table of Contents
Advertisement
6/39
Intended use
3.4 Explaining the signal alert symbol on the device
krax
4 Intended use
4.1 General information
The PY-MSS01.1-T1 mark stream sensor is intended for use together with a drive
system and the corresponding software of the Bosch Rexroth company.
The PY-MSS01.1-T1 mark stream sensor was checked by an external technical in-
spection authority (German TÜV SÜD Product Service GmbH). The conformity of
the PY-MSS01.1-T1 mark stream sensor was confirmed with a test report and an
official test number.
Only commission the product after you have thoroughly read, under-
stood and complied with the documents and safety instructions pro-
vided with the product
If no documents are available in your national language, please con-
tact your Bosch Rexroth distribution partner.
The PY-MSS01.1-T1 mark stream sensor can only be commissioned in explosive
environment if
all following information on the commissioning and the application notes of
●
the application description "IndraMotion MLC 14VRS RegisterControl" (see
tab. 1-2 "Related documents" on page
the entire system consisting of mark stream sensor, optic sensor, cable and
●
accessories was checked, approved and documented according to the rele-
vant standard requirements
Bosch Rexroth AG R911341913_Edition 05
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
3) were understood and implemented
MLC 14VRS RegisterControl ATEX
Advertisement
Table of Contents
