Preparation For Work; Turning On The Device; Setting The Temperature; Function - Electrolux ECH-1000 M EEC User Manual

6
www.home-comfort.com

Preparation for work

1. Carefully remove the heater from the card-
board box.
2. Remove the colored stickers from the front
panel before use.
3. At the first start-up, some odor may
appear, which will disappear after the con-
vector starts to work.
4. Fix the device in a stable position accord-
ing to the assembly and installation instruc-
tions.
5. After installing the convector, plug it into a
power outlet. It is not recommended to use
the same electrical outlet for simultaneous
plugging in heater and other high power
electrical appliance.

Turning on the device

Insert the plug into a power outlet, the power
indicator will light up and stay on. Set the
on / off button on the control unit to the
mode, or turn the thermostat control knob
on the top panel to the right, so that the
device starts working and you can select the
required heating temperature. If the ambient
temperature is lower than the set one, the
convector starts to work, if the ambient
temperature becomes higher than the set one,
the device automatically turns off and goes
into standby mode, and then turns on again
when the room temperature drops.

Setting the temperature

To set the required heating temperature
and maintain a constant room / premises
temperature, turn on the device at full power,
turn the thermostat control knob to the right to
the maximum value.
When the room / premises temperature
reaches a comfortable level for you, slowly
turn the thermostat control knob to the left
until you hear a click. Thus, the device will
remember the temperature that is comfortable
for you and will maintain it by automatically
switching on and off.
The difference between the on / off
temperatures for the set value can be
between 0.1 °C and 3 °C, depending on
the volume and thermal insulation of the
room / premises. We recommend that
when operating the device in large rooms
/ premises subject to rapid cooling, set the
temperature 2 - 3 °C higher than the desired
one for more efficient operation of the
heater.
"Overheating protection" function
The device is equipped with an automatic
switch that is activated when the upper
temperature limit is reached. The heater
switches off automatically in case of
overheating. After eliminating the source
of overheating, the heater will turn on
automatically.

Installation of the device

The device must be fixed in accordance with
the regulations.
The switch and other mechanisms must
stay away from splashing water. It is strictly
forbidden to cover or plug the air inlets or
outlets (grilles), due to the risk of accident or
damage to the device. Do not place behind
curtains, doors, wall or air vents. Observe
the minimum installation distances on floors,
surfaces, furniture, etc (Figure. 3).
100 mm
min.
Figure. 3
Floor installation
Using the chassis (supplied separately), having
previously studied the mounting scheme (Fig.
6), install the device on the floor:
1. Carefully turn the convector upside down
(Fig. 4).
2. Take one of the chassis and attach to the
landing area on the right or left side of the
100 mm
min.
100 mm
min.