Getting To Know Your Appliance; The Control Panel; The Hotplates; Hotplate And Residual Heat Indicators - Bosch PKE6 CA1 Series Instruction Manual

*Getting to know your
appliance
The instruction manual is the same for various different
y o u r a p p l i a n c e G e t t i n g t o k n o w
hobs. You can find the hob dimensions in the overview
of models. ~ Page 2

The control panel

Hotplate controls
The hotplate controls are permanently fixed. They must
not be removed. Forcibly removing the hotplate controls
leads to them being destroyed.

The hotplates

Hotplate Activating and deactivating
Single-circuit
$
hotplate
Dual-circuit Activation: turn hotplate switch to the right as far
ð
hotplate
as ð . Setting the heat setting. Switching off:
Turn the hotplate switch to 0 and reset. Never
turn the hotplate switch past the symbol
Notes
Any dark areas in the glow pattern of the hotplate
■
are due to technical reasons. The function of the
hotplate is not affected.
Hotplate temperature is regulated by the heat
■
switching on and off. The heat may also switch on
and off at the highest setting.
With multi-circuit hotplates the heater elements of the
■
inner filament circuits and the heater element of the
activations may switch on and off at different times.

Hotplate and residual heat indicators

The hotplate and residual heat indicators light up when
a hotplate is warm:
Hotplate indicator - during operation, shortly after
■
you have switched on a hotplate.
Residual heat indicator - after cooking, when the
■
hotplate is still warm.
You can use the residual heat to save energy, e.g. to
keep a small dish warm or to melt chocolate.

1Operating the appliance

In this section, you can find out how to set the hotplates.
p l i a n c e O p e r a t i n g t h e a p
The table shows heat settings and cooking times for
various meals.

Switching the hob on and off

You can switch the hob on and off with the hotplate
controls.

Setting a hotplate

Adjust the heat setting of the hotplates using the
hotplate controls.
Heat setting 1 = Lowest setting
Heat setting 9 = Highest setting
The symbol in the display panel indicates the hotplate
which the display refers to, e.g.
hotplate.
ð to 0.

Getting to know your appliance

for the right rear
Š
en
5