Husqvarna HA322 Operator's Manual page 6

Personal protective equipment
WARNING:
instructions that follow before you use the
product.
• Long-term exposure to noise can result in permanent
hearing impairment. Always use approved hearing
protection.
• Always wear protective, non-slip boots.
• Always wear helmet, eye protection, and gloves.
• Always wear working clothes and heavy-duty long
trousers.
• Never wear loose clothing or jewelry.
• Make sure your hair does not hang below shoulder
level.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
In this section the product's safety features, its purpose
and how checks and maintenance should be carried
out to ensure that it operates correctly. See instructions
Introduction on page 2 to find where
under the heading
these parts are located on your product.
The life span of the product can be reduced and the risk
of accidents can increase if product maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest servicing dealer.
WARNING:
defective safety components. The product's
safety equipment must be inspected and
maintained as described in this section.
If your product fails any of these checks,
contact your service agent to get it repaired.
CAUTION:
on the machine requires special training.
This is especially true of the machine's
safety equipment. If your machine fails
any of the checks described below you
6
Read the warning
Read the warning
Never use a product with
All servicing and repair work
must contact your service agent. When
you buy any of our products we guarantee
the availability of professional repairs and
service. If the retailer who sells your
machine is not a servicing dealer, ask him
for the address of your nearest service
agent.
To do a check of the blades
1. Stop the product.
a) If you have a gasoline operated product, switch
off the engine and disconnect the spark plug cap
from the spark plug.
b) If you have a battery operated product, switch off
the motor and remove the battery.
2. Make sure that the product has stopped completely.
3. Put on protective gloves.
4. Make sure that the blades are not damaged or bent.
Always replace a damaged or bent blade.
5. Make sure that the screws to the blades are not too
loose. If a screw is loose, tighten sufficiently.
Note:
Do not tighten the screws to the blade too
much. Too tight screws prevent blade movement.
Hot surface
The gear housing gets hot when the product has been
in use. Do not touch the gear housing to avoid burning
yourself.
Safety instructions for maintenance
Read the warning instructions that follow before you use
the product.
• Always stop the product before you work on any
part of the cutting equipment. If you have a gasoline
operated product, disconnect the spark plug cap
from the spark plug. If you have a battery operated
product, remove the battery. Check that the cutting
equipment has stopped completely before you start
any work on it.
• The transport guard should always be fitted to the
cutting attachment when the product is not in use.
• Make sure the cutting attachment has stopped
before cleaning, carrying out repairs or an
inspection. If you have a gasoline operated product,
disconnect the spark plug cap from the spark plug.
If you have a battery operated product, remove the
battery.
1917 - 001 - 18.07.2022