Table of Contents
Advertisement
13. Troubleshooting
Phenomenon
Night light
function
Night light on
Automatic retracting
of nozzle
Manual
cleaning
nozzle
Long press" Water
mode
temperature "
button, the nozzle
out too slowly
Low water
Rear wash/
pressure
Front wash/
Children
wash
Low water
temperature
The nozzle suddenly
stops spraying water
The temperature of
the seat is not high
enough during use
Seat
heating
Over-temperature
of seat
Cause
The night light is set to "on".
The nozzle will be automatically
retracted 2 minutes after manual
cleaning.
There are conductive media on
the seat, such as water droplets
or wet paper, etc. The sensor will
identify it as user.
When the front or rear wash
function is activated, the nozzle
will be automatically cleaned at
The water pressure is set to a
lower mode.
The screen is clogged.
The connecting nut of water supply
hose is loosened.
The water temperature is set to
"low" or "normal temperature".
After 3 minutes of cleaning, the
nozzle stops spraying water and
retracts automatically.
The seat temperature is set to
"normal temperature" or "low".
The seat temperature is set to
a higher level.
22
Solution
Turn on the power supply.
Reset the night light assembly to
"turn on" the night light.
Reset the night light assembly to
This is a normal phenomenon.
Remove the conductive medium
on the seat.
This is a normal phenomenon.
Use the remote control to reset the
water pressure to a stronger mode.
Clean the screen or replace the
Fasten the nut.
Use the remote control to reset
the water temperature to a "high"
or "medium" state.
This is a normal phenomenon.
Reset the seat temperature to a
higher state.
Reset the seat ring temperature
to a lower state.
Advertisement
Table of Contents
