Frigidaire FGTR1837TD Use & Care Manual page 6

INSTALLATION
To level the cabinet using the front
rollers:
1 Remove the toe grille.
2 Use a flat-blade screwdriver or ⅜ inch
socket wrench to raise or lower the front
rollers (Figure 2). Do not raise the cabinet
more than /
9
16
9/16"
(14 mm)
Max
3 Use adjustable wrench to adjust leveling
screws. Lower the leveling screws on each
side clockwise until they contact the floor
(Figure 3). Do not raise the cabinet more
than / inch.
9
16
9/16"
(14 mm)
Max
Figure 3

NOTE
Raise the front of the refrigerator enough so
the doors close freely when opened halfway.
The refrigerator should slope ¼ inch to ½
inch from front-to-back. Then level the refrig-
erator from side-to-side.
6
inch.
Raise
Figure 2
OR
Raise
4 Some models are equipped with an anti-
tip bracket (Figure 4). Lower it clockwise
until it contacts the floor.
Anti-tip
Bracket
Figure 4 (some models)
WARNING
The anti-tip device must be
installed according to the
instructions in your Use &
Care Manual. Failure to do
so will result in injury.
WARNING
When reversing the door swing:
You MUST move the anti-tip bracket to align
with the hinges of the door. Failure to do so
will result in injury.
Lower